Alula RE222 NanoMax Instructions Download Page 4

Physical 

Housing Dimensions
Weight with Battery
Mounting Fastener

1.80 x 0.77 x 0.39 inches (4.6 x 2.0 x 1.0 cm)
0.53 ounces (15 grams)
3M VHB Tape 

Environmental

Operating Temperature
Maximum Humidity

32 to 120 °F  (0 to 49 °C)
85% non-condensing relative humidity

Sensor Specifications

Frequency
Replacement Battery
Nominal Battery Life
Battery Voltage
Current Draw
Transmitted Indications

345 MHz
One Panasonic CR1632
6 years
3.0 VDC (Nominal), 2.62VDC (Low)
20 mA (Maximum), 0.5uA (Quiescent)
Cover Tamper, Low Battery, Supervision 

Certifications

RE222

UL634, ULC634, ETL, FCC, IC

Specification subject to change without notice

Specifications

47-0006-02 • REV C • 2018-02-28

Tech Support Line • (888) 88-ALULA • (888) 882-5852

alula.net

WARRANTY

Alula Holdings, LLC will replace products that are defective in their 

first five (5) years.

IC NOTICE

This device complies with Industry Canada license-exempt RSS 

standard(s). Operation is subject to the following two conditions:
(1) This device may not cause interference, and

(2) This device must accept any interference, including interference 

that may cause undesired operation of the device.

Le présent appareil est conforme aux cnr d’Industrie Canada 

applicables aux appareils radio exempts de licence. L’exploitation 

est autorisée aux deux conditions suivantes:
(1) L’appareil ne doit pas produire de brouillage, et

(2) L’utilisateur de l’appareil doit accepter tout brouillage 

radioélectrique subi, même si le brouillage est susceptible d’en 

compromettre le fonctionnement.

IC: 8310A-RE222

FCC NOTICE

This device complies with Part 15 of the FCC rules. Operation is 

subject to the following two conditions:
(1) This device may not cause harmful interference.

(2) This device must accept any interference that may be received, 

including interference that may cause undesired operation.

Changes or modifications not expressly approved by the Alula 

Holdings, LLC could void the user’s authority to operate this 

equipment.
FCC ID: U5X-RE222

TRADEMARKS

Alula and NanoMax are trademarks owned by Alula Holdings, LLC.

“Honeywell” is a trademark owned by Honeywell International, Inc.

Alula Holdings, LLC products will function with Honeywell systems.  

However, no Alula Holdings, LLC product is produced by, endorsed 

by, or officially associated with Honeywell.  Alula Holdings, LLC 

recommends verifying proper enrollment and operation, per control 

panel installation instructions, at installation.

00

Summary of Contents for RE222 NanoMax

Page 1: ...ent sequence needed by Honeywell panels Sensor trips should be spaced by two seconds when enrolling Install by removing the adhesive paper and adhering the NanoMax and magnet on a door or window Make sure to align the alignment marks on the NanoMax and magnet when mounting Alternatively NanoMax can be used with an external contact instead of using the reed switch External Contact not evaluated by ...

Page 2: ... performance is optimized when mounted near the top of the door in a vertical orientation OK BEST WRONG Accessories MetalMax NanoMax Mounts RE033 16 can be used for better performance on metal and narrow mounting situations Improves wireless performance by moving the internal antenna away from metal surfaces Provides an alternate mounting orientation for narrow installs Increases magnet gap distan...

Page 3: ...inches 4 3 cm 1 75 inches 4 5 cm 1 10 inches 2 8 cm 1 15 inches 3 0 cm Ferromagnetic Surface Using RE033 Mount Nominal Mounting Distance X Axis Make Break Y Axis Make Break Z Axis Make Break 0 50 inches 1 2 cm 0 55 inches 1 4 cm 0 60 inches 1 5 cm 1 50 inches 3 8 cm 1 55 inches 4 0 cm 0 70 inches 1 8 cm 0 75 inches 2 0 cm Magnet Gap Specifications Z Axis X Axis Y Axis ...

Page 4: ...n of the device Le présent appareil est conforme aux cnr d Industrie Canada applicables aux appareils radio exempts de licence L exploitation est autorisée aux deux conditions suivantes 1 L appareil ne doit pas produire de brouillage et 2 L utilisateur de l appareil doit accepter tout brouillage radioélectrique subi même si le brouillage est susceptible d en compromettre le fonctionnement IC 8310A...

Reviews: