24
ALTUS
|
3731 Northridge Dr, NW
|
Suite 1
|
Walker, MI 49544
|
T: 888.537.1311
I
www.altus-inc.com |
AS-1584_Rev.I
Power System Removal and Replacement
Power System should only be accessed if approved by Altus
Always unplug the power cord from the wall outlet when
removing the Power System.
Power System Removal
#2 Phillips Screwdriver and 1/8” Allen Wrench
Step 1: Power Down System
A. Turn off any components plugged into cart
B. Turn off Power System by Holding On/Off
Button for 2 seconds
Step 2: Unplug Power Cord from Wall Outlet
Step 3: Remove front panel (1/8” Allen Wrench needed)
A. Loosen and remove (2) screws from sides (See Fig A)
Step 4: Remove controller from base (Phillips Head Screwdriver needed)
A. Loosen and remove (2) screws (See Fig B)
B. For Ascend EL Carts, slide out controller (See Fig. B).
Step 5: Gently slide controller out of base.
Step 6: Disconnect Cables (6) from Power System
A. Unplug Black and Grey CAT 5 cables from unit (See Fig C)
B. Unplug Blue CAT 5 Smart Battery Cable from unit (See Fig C)
B. Unplug USB cable from unit (See Fig D)
C. Unplug Yellow cable from unit (See Fig D)
D. Unplug AC Input In/Out Power cords. (See Fig D)
Step 6: Remove Power System
Step 7: Replace with New Power System
Repeat steps 1-6 in reverse.
Technology W
orkstation Solutions — Powered
air
(2) Screws - Phillips drive
(Fig. B)
USB cable
(Fig. D)
(2) Screws on both sides
(Fig. A)
Controller Slots
(Fig. C)
Slide out controller in
Ascend EL Carts
Fig. E
(Battery
terminals)
Located
in back on
Ascend EL
