- 2 -
Trove ZKTeco Kits Installation Guide
Overview:
Altronix T2ZK7F8 and T2ZK7F16 Trove ZKTeco kits are pre-assembled and consist of Trove enclosures/backplanes with factory installed Altronix
power supply/chargers and sub-assemblies.
T2ZK7F8 accommodates up to two (2) ZKTeco modules for up to eight (8) doors in a single enclosure.
T2ZK7F16 accommodates up to four (4) ZKTeco modules for up to sixteen (16) doors in a single enclosure.
Configuration Chart:
Altronix
Model Number
120VAC 60Hz Input Current (A)
Power Supply Board Input Fuse Rating
Power Supply Board Battery Fuse Rating
Maximum Supply
Current for Main and
Aux. Outputs on
Power Supply board
and ACM8 Access
Power Controllers’
outputs
Nominal DC Output
Voltage
Fail-Safe/Fail-Secure or Dry Form “C” Outputs
Additional Fused Outputs
ACM8 Board Input Fuse Rating
ACM8 Board Output Fuse Rating
PDS8 Board Input Fuse Rating
PDS8 Board Output Fuse Rating
[DC]
[Aux]
Output
Range
(VDC)
Output
Range
(VDC)
T2ZK7F8
4.5 6.3A/
250V
15A/
32V
24VDC @ 9.7A
20.17-26.4 20.28-26.4
8
8
10A/
250V
2.5A/
250V
10A/
32V
3A/
32V
T2ZK7F16
24VDC @ 9.4A
16
Installation Instructions:
Wiring methods shall be in accordance with the National Electrical Code/NFPA 70/ANSI, and with all local codes and authorities having jurisdiction.
Product is intended for indoor use only.
1. Remove backplane from enclosure. Do not discard hardware.
2. Mark and predrill holes in the wall to line up with the top two/three keyholes in the enclosure. Install two/three upper fasteners and
screws in the wall with the screw heads protruding. Place the enclosure’s upper keyholes over the two/three upper screws;
level and secure. Mark the position of the lower three holes. Remove the enclosure. Drill the lower holes and install the three
fasteners. Place the enclosure’s upper keyholes over the two/three upper screws. Install the three lower screws and make sure to
tighten all screws.
3. Mount included UL Listed tamper switch (Altronix Model TS112 or equivalent) in desired
location, opposite hinge. Slide the tamper switch bracket onto the edge of the enclosure
approximately 2” from the right side
(Fig. 1, pg. 2)
. Connect tamper switch wiring to the
Access Control Panel input or the appropriate UL Listed reporting device.
To activate alarm signal open the door of the enclosure.
4. Mount ZKTeco modules to backplane, refer to
pages 3 - 6
.
5. Refer to the
eFlow Power Supply/Charger Installation Guide
for eFlow104NB and
corresponding
Sub-Assembly Installation Guides
for ACM8, PDS8 and VR6 for
further installation instructions.
Hardware:
Fig. 1
Tamper Switch
(provided)
To Access Control Panel or
UL Listed Reporting Device
Edge of
Enclosure
Enclosure
Nylon Spacer | 5/16” Pan Head Screw | Lock Nut
