Note: When it is required to have the same event repeated on two (2) or more consecutive days of the week, the event must be
programmed as a block by selecting
BK
in the day field.
A01 OFF
BK 00:00
Note: To program the consecutive days of the week refer to Setting Block Event (weekly repeat) and Daylight Savings Time -
section C1 below.
2. Adding Events
Depress
SET
until
ENTER to
SET EVENT
Depress
ENTER
A01 OFF
SU 00:00
Depress
ENTER
, if the event is not programmed, the cursor will move to the OFF (relay function) position. If the event is pro-
grammed the cursor will move to the position and the programmed information of the event will be displayed. At this point
depress the UP button to step up through the programmed events. When an unprogrammed event is reached the cursor will move to
the OFF (relay function position). (At this point refer to setting events or setting holiday events).
C. Setting Block Events (weekly repeat) and Daylight Savings Time:
Select chanel A or B by moving slide switch SW3 to appropiate position.
Note: Channel cannot be changed in the middle of programming events. To change channels you must exit programming then
change channel switch position then enter program mode again.
Depress
SET
until
ENTER to
SET BK
Depress
ENTER
A=SA/SU
TIME=DS
1. Block Event Programming
Flashing cursor will appear at the location of the first day of the week desired. Depress
UP
and
DWN
to select day.
Depress
ENTER
to confirm selection, then cursor will appear at the location of the last day of the week desired.
Depress
UP
and
DWN
to select day. Depress
ENTER
to confirm selection.
1) Monday through Thursday depress
MO
followed by
TH
.
2) Wednesday through Sunday depress
WE
followed
SU
.
2. Daylight Savings Programming
The cursor will appear under DS (auto clock adjust daylight savings mode) in display. To change mode depress
UP
or
DWN
once ST (clock does not adjust standard time mode) will appear in display. Depress
ENTER
to accept correct selection.
Note: Select
DS
for areas that observe daylight savings or
ST
for areas that don’t observe daylight savings.
D. Setting Holiday Events: (These events will occur on programmed Holiday Dates - see Setting Holiday Dates below).
Select chanel A or B by moving slide switch SW3 to appropiate position.
Note: Channel cannot be changed in the middle of programming events. To change channels you must exit programming then
change channel switch position then enter program mode again.
Find the first unprogrammed event (refer to Adding Events - section B2 page 6).
Depress
ENTER
until the flashing cursor appears under OFF (relay function) position in display. Now select type of operation
required, by scrolling using the
UP
and
DWN
push buttons until either:
ON - Relay ON (latching mode).
OFF - Relay OFF (latching mode).
PL - Relay Pulse ( momentary).
appears in display and depressing
ENTER
will make selection.
When selecting the pulse mode PL01 will appear in the display. It is now necessary to assign the length of time (duration of
relay activation). The pulse can range in length from 1 second minimum to 15 seconds maximum and is selected by using
UP
or
DWN
push buttons, then depressing
ENTER
to accept.
Note: If pulse duration is not selected relay output defaults to 1 second.
Next select
HL
(holiday) and time (military) by scrolling using
UP
and
DWN
push buttons and depress
ENTER
to accept.
You may continue to program events by repeating the previous steps or exit programming by depressing
SET
.
appears in display.
will appear in display.
appears in display.
will appear in display.
5
>
>
>