UP
and
DOWN
keys can be used to select data entries. After scrolling to the correct entry, depress
ENTER
to accept.
SW2 clip SW
Selects tandem or individual relay operation.
SW3 slide SW
Selects channel to be programmed.
Programming Instructions:
The flashing cursor denotes location of data entry selection to be made. If an entry was made in error or requires changing,
depress
SET
to backspace, make the correct selection and depress
ENTER
to accept data and advance the cursor.
A. Setting Clock/Calendar:
Upon initial power up
CH ON
SU 01:01
Depress
SET
until
ENTER to
SET TIME
Depress
ENTER
01/01/01
SU/01:01
Enter the current date, day of week and time (military) by depressing
UP
and
DWN
to make the selection then depress
ENTER
to accept.
To program Daylight Savings Time (refer to Setting Block Events (weekly repeat) and Daylight Savings Time - section C 2,
page 6).
To change or program clock/calendar simply repeat the steps above.
B. Setting Events and Adding Events:
Select chanel A or B by moving slide switch SW3 to appropiate position.
Note: Channel cannot be changed in the middle of programming events. To change channels you must exit programming then
change channel switch position then enter program mode again.
1. Setting Events
Depress
SET
until
ENTER to
SET EVENT
Depress
ENTER
A01 OFF
SU 00:00
Note: A01 indicates Channel A event 01.
When cursor appears you are able to scroll through events.
Depress
ENTER
until the flashing cursor appears under OFF (relay function) position in display. Now select type of operation
required, by scrolling using the
UP
and
DWN
push buttons until either:
ON - Relay ON (latching mode).
OFF - Relay OFF (latching mode).
PL - Relay Pulse ( momentary).
appears in display and depressing
ENTER
will make selection.
When selecting the pulse mode PL01 will appear in the display. It is now necessary to assign the length of time (duration of
relay activation). The pulse can range in length from 1 second minimum to 15 seconds maximum and is selected by using
UP
or
DWN
push buttons, then depressing
ENTER
to accept.
Note: If pulse duration is not selected relay output defaults to 1 second.
Next select the individual day of the week by scrolling using
UP
and
DWN
push buttons and depress
ENTER
to accept.
Next select the hour and minutes the event is to occur by scrolling using
UP
and
DWN
push buttons and depress
ENTER
to accept.
You may continue to program events by repeating the previous steps or exit programming by depressing
SET
.
Note: When programming additional events it is necessary to select the next consecutive event number following the last event
program to continue.
will appear in display.
appears in display.
will appear in display.
appears in display.
will appear in display.
>
>
4