10
After selecting a data base you can exit out of SETUP if you have
already previously configured it and do not wish to make any changes.
After selecting a data base the following is displayed:
ET MODE = 1
TS MODE
= 2
JET MODE = 3
PLATE MODE =4
Select Mode
ET MODE:
By pressing "1" sets the unit to the ET MODE. This means
all runs added to the data base will be stored in the ET section and the
PREDICTION will be an ET computed from the stored runs and the
present ALTITUDE.
TS MODE:
By pressing "2" sets the unit to the TS MODE (Throttle Stop
Mode). This means all runs added to the data base will be stored in the
TS section and the PREDICTION will be a TS or timer setting
computed from the stored runs and the present ALTITUDE.
After pressing "2" another menu is displayed as follows:
TS MODE SELECTED
index = 9.90
CHANGE?
YES = 1 NO = 2
If the user presses "1" the following will be displayed:
ENTER INDEX
Now the user can enter an index, such as 8.90, then he must press the
ENTER key.
Select Method
For Prediction
Multiple Runs =1
One Run =2
Multiple Runs:
When the multiple run prediction method is selected, predictions are then
calculated from the runs stored in the data base.
