6
4)
Connect supplied power cable to 12v DC Source (Trailer battery or
equivalent). It is not recommended to charge battery or have generator
running while system is in use. If generator is used, high voltage transient
suppression equipment connected in line is recommended.
Solid black wire
is
NEGATIVE
;
Black with white stripe wire is
POSITIVE
.
*
IMPORTANT
*
Fuse positive power cable with a 5amp quick blow fuse
. Power
down system before disconnecting power to avoid data loss. Do not
lengthen power wires. If you have a 110AC power outlet, an adapter is
available to connect to system: Part# ALT-PWC-POWER-ADPT
MOUNTING ANTENNA
Mount antenna for paging option as high up as possible on top edge of trailer. Do not
mount above top of trailer. Mount to trailer, not to a post or other fixture. Antenna can
be thru hole mounted in top of trailer or attached to trailer with angle bracket supplied.
Follow instruction supplied with antenna for installation. **NOTE** Rod length of
antenna does not need to be altered. To mount on post Part # PWC-ANTENNA-GPA is
needed!
Cable Lock Installation
Step 1:
Assemble Parts as shown
below
Step 2:
Slide Cable Lock over cable.
Then snap cable into sensor housing.
Step 3:
Slide Cable Lock over the
cable and tighten thumbscrew #1 to
fasten to Sensor Housing Body.
Step 4:
Tighten thumbscrew #2
snugly to provide strain relief. Please
do not over tighten.
*Note: To remove cable, both thumbscrews need to be loosened and lock needs to be
slid back on cable before cable is detached from connector.
