ROOF PANELS
Fixing roof Vents and Caps
If you have roof vents adjacent (either side) to
each other you will have to trim the vent caps as
detailed in fig 7. Note: if you have more than one
set of adjacent roof vents, these will require
cutting at both ends
fig 7
7
/
8
” / 22m
m
Ventilator Cap
fig 8
Fix the plastic tongue in the slot between the two
4
1
/
2
” / 114mm
roof panels. See fig 8.
Roof
Vent
Roof Section
Roof Section
Roof Vent
Roof Vent
Roof Section
Roof Section
Bend the plastic tongue over on itself when you
push the end into the slot. This will prevent it
from sliding back out and you may find it easier to
accomplish this by gripping the folded end with a
pair of pliers.
Note: It is correct that the end of the roof section
does not line up flush with the gable end.
Finally check that all nuts and bolts are tightened
before proceeding to the next instruction.
Leave the casement fittings or automatic openers
until later.
Follow the same procedures for fitting the
remaining roof sections in place.
Where roof sections meet each other use the
shorter 2
3
/
4
”/70mm bolts and fix with a washer
and nut.
Fit any other roof vents and vent caps.
page 14
fig 9
1”/24mm Nails
Ventilator cap
‘U’ Ridge brackets
5
/
8
” / 15mm bead of mastic
Phone Summer Greenhouses free 7 days a week on 0800 9777 828 or visit www.SummerGreenhouses.com
