AC Inlet
Please don't plug power cord into unit and AC power if voltage has not been correctly set.
Inputs & Outputs
6
Your unit may have the AC voltage selector (
115V/60Hz or
230V/50Hz) built into the Fuse Holder.
To change,
pull fuse-holder out and rotate 180 , then push in again.
discontinue use of this unit before repaired.
Fuse holder & voltage selector
110-120V
220-240V
THIS IS SET FOR
110V AC TO 120V
AC OPERATION
THIS IS SET FOR
220V AC TO 240V
AC OPERATION
220-240V
110-120V
The fuse-holder above the AC connector on the rear of the chassis has 3 triangular markers (please refer
to the
above pictures), with two of these triangles opposing each other, your unit is set to the operating Voltage printed
next to these markers.
Phase inversion
cancellation in some fields can be compensated for.
Mode switch
when it is pressed. On the contrary, you are able to operate it as 2-way stereo crossover (High/Low) when it is
released.
CD Boost
3.5kHz, then +6dB per octave till 22.5kHz.
Caution
: The fuse protecting the AC supplies circuits of this unit. The fuse can only be changed by a qualified
technician, in the event of a fault or changing the supply voltage. If the fuse continues to blow after replacing,
The inputs and outputs can be used as balanced and unbalanced XLR and
TRS connectors, they can be used
1/4"
to input and output signals.
Abbreviation for 'Constant Directivity Boost', this button can be used to boost the high frequencies by +3dB at
Through this function and using with the horns, power loss of the high frequencies can be compensated for during
the long distance transmission in the large PA reinforcement systems.
This button will reverse the phase of the corresponding frequencies output by 180 , so that, the frequencies
It can set the operational mode of this unit. You are able to operate it as a 3-way mono crossover (High/Mid/Low)
