IMPORTANT SAFETY INSTRUCTION
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
TO REDUCE THE RISK OF ELECTRIC SHOCK
PLEASE DO NOT REMOVE THE COVER OR
THE BACK PANEL OF THIS EQUIPMENT.
THERE ARE NO PARTS NEEDED BY USER
INSIDE THE EQUIPMENT. FOR SERVICE,
PLEASE CONTACT QUALIFIED SERVICE
CENTERS.
WARNING
To reduce the risk of electric shock
and fire, do not expose this equipment
to moisture or rain.
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
Dispose of this product should
not be placed in municipal waste
and should be separate collection.
11.
12.
Move this Equipment only with a cart,
stand, tripod, or bracket,
specified by the
manufacturer, or
sold with the
Equipment. When
a cart is used, use
caution when
moving the cart /
equipment
combination to
avoid possible
injury from tip-over.
Permanent hearing loss may be caused by
exposure to \ extremely high noise levels.
The US. Government's Occupational Safety
and Health Administration (OSHA) has
specified the permissible exposure to noise
level.
These are shown in the following chart:
HOURS X DAY SPL EXAMPLE
According to OSHA, an exposure to high SPL in
excess of these limits may result in the loss of
heat. To avoid the potential damage of heat, it is
recommended that Personnel exposed to
equipment capable of generating high SPL use
hearing protection while such equipment is
under operation.
8
6
4
3
2
1,5
1
0,5
0,25 or less
90
92
95
97
100
102
105
110
115
Small gig
train
Subway train
High level desktop monitors
Classic music concert
Rock concert
This symbol, wherever used, alerts you to the
presence of un-insulated and dangerous voltages
within the product enclosure. These are voltages that
may be sufficient to constitute the risk of electric
shock or death.
This symbol, wherever used, alerts you to
important operating and maintenance instructions.
Please read.
Protective Ground Terminal
AC mains (Alternating Current)
Hazardous Live Terminal
ON:
Denotes the product is turned on.
OFF: Denotes the product is turned off.
The apparatus shall be connected to a mains
socket outlet with a protective earthing
connection.
The mains plug or an appliance coupler is used
as the disconnect device, the disconnect device
shall remain readily operable.
CAUTION
Describes precautions that should be observed to
prevent damage to the product.
Read this Manual carefully before operation.
Keep this Manual in a safe place.
Be aware of all warnings reported
with this symbol.
Keep this Equipment away from water and
moisture.
Clean it only with dry cloth. Do not use
solvent or other chemicals.
Do not damp or cover any cooling opening.
Install the equipment only in accordance with
the Manufacturer's instructions.
Power Cords are designed for your safety. Do
not remove Ground connections! If the plug
does not fit your AC outlet, seek advice from
a qualified electrician. Protect the power
cord and plug from any physical stress to
avoid risk of electric shock. Do not place
heavy objects on the power cord. This could
cause electric shock or fire.
Unplug this equipment when unused for long
periods of time or during a storm.
Refer all service to qualified service personnel
only. Do not perform any servicing other than
those instructions contained within the
User's Manual.
To prevent fire and damage to the product,
use only the recommended fuse type as
indicated in this manual. Do not short-circuit
the fuse holder. Before replacing the fuse,
make sure that the product is OFF and
disconnected from the AC outlet.
8. TECHNICAL SPECIFICATION
Power Section (SPK.OUT)
Speaker Section
Statis Power Consumption
Dielectric Strength
Insulation Resistance
Power supply
Physical
FAT analysis
MP3 DECODE
Electric Specification
Distortion
Frequency Response
SNR (Line IN)
Output level
Power continuous 1KHz,THD 1%
Power EIAJ 1KHz,THD 1%
Thermal protection
Short protection
Voltage protection
Passive System Type
Continuous Power
Peak Power
Max SPL at 1M
Frequency Response
Impedance
Crossover Frequency
Protection
Coaxial Type Low Frequency Driver
High Frequency Driver
Coverage HxV
Connectors
No Output powerstate at 230V
Between Live+Negative
Earth
Between Live+Negative
IN/OUT
Terminal(PNegative)
Between Live+Negative
Earth(A Voltage of 500VDC)
Between Live+Negative
IN/OUT Terminal(PNegative)
(A Voltage of 500VDC)
Main voltage
Dimension (W D H)
Net Weight
Cross Weight
Supports FAT 16 and FAT 32, Supports VFAT (long file
name), Supports multi-partion up to 1
Supports sample rates 8KHz, 32KHz, 11.025KHz,
22.05KHz, 44.1KHz, 12KHz, 24KHz, and 48KHz.
Supports bit rate 8 to 320 kbps and VBR (Variable Bi
Rate) except free format
Frequency Response 20Hz~20KHz
Output level 0 dB
S/N Ratio > 90 dB
Distortion (at 1 KHz) <0.05%
<0.1% (at 1W & 1 KHz)
<0.15% (at 100W & 1 KHz)
20Hz to 22kHz, +/-2dBu (at 100W)
100 dBu
30.5dBu +/-1dBu (+10 Led Light & COMP.Start)
2 X 200W @ 4
2 X 110W @ 8
2 X 250W @ 4
2 X 130W @ 8
over-temperature power limiting
thermal shutdown
Temperature controlled 12V DC fan output
short-circuit protection
overload output protection
over voltage protection
DC offset shutdown
2 -way Coax vented box
150W AES standard (each speaker)
300W Peak (each speaker)
117.5dB SPL calculated
65Hz-20KHz at -10dB
8
nominal
2.3KHz/12dB/Oct
Electronic on the Driver
10
Woofer / 2
Voice Coil
1
Neodymium Driver / 1
Voice Coil
70 Hx70 V Spherical hom
Power Input with mono Jack
32W
1500VAC at Test,Frequency 50/60Hz,Leakage
Current:5mA for 1minute
3000VAC at Test,Frequency 50/60Hz,Leakage
Current:5mA for 1minute
2M
4M
100-120VAC~60Hz
220-240VAC~50Hz
100~120V: T10A 250V
220~240V: T5A 250V
984mm*440mm*460mm (38.7
x17.3
x18.1
)
19.61kg
25.41kg
19
