11 PRESETS
Adjust this knob to select the right effect you wish to perform. There are total
16 options for you: WARM HALL,BRIGHT HALL, WARM ROOM, BRIGHT ROOM,
VOCAL 1, VOCAL 2, VOCAL 3, PLATE, STEREO DELAY1,STEREO DELAY2, REV
+ DELAY1, REV + DELAY2, REV + DELAY3, REV + DELAY4, REV + CHORUS1
and REV + CHROUS2.
FX RETURNS
FX SEND
10
0
+10
-
8
FX RET
LEVEL
CD/TAPE
L
OUT
R
L
R
IN
L
R
PHONES
MASTER
+10
LEVEL
-
8
POWER
SPK.OUT
(MIN. LOAD 4 Ohms)
OUTPUT
LEVEL
+10
0
-10
L
R
-30
SPO
TLIG
HT
4. CONTROL ELEMENTS
13 DSP MUTE SWITCH
This switch is used to activate/deactivate the effect facility.
14
16
23
24
22
19
17
18
15
21
20
14 POWER LED
When you switch on the apparatus,the LED will light on.
15 MASTER LEVEL CONTROL
This control is used to adjust the overall volume of main mix output, and the
signal also input to the preamplifier.
16 MASTER LEVEL LED
The 4-segment LED metre is used to indicate the master output level. When
the red LED lights on, it means that the MIX OUT r10dB, or start
the compressor from the build in AMP.
SPO
TLIG
HT
4. CONTROL ELEMENTS
USB PORT
For connecting with USB memory.
PREVIOUS
In pause state, press this button it will go to the previous song and keep
in pause state. In play state, press this button it will go to the previous song
and start playing.
In pause state, press this button it will go to the next song and keep in
pause state. In play state, press this button , it will go to the next song
and start playing.
NEXT
Press this button the player will change between the following four modes. REP
ALL means to repeat all songs in the memory, the mark on the screen is
REPEAT
.
REP1 means to repeat one song, the mark on the screen is
Play in order
means to play the songs according to the order, the mark on the screen is
blank. Random play means to play the songs at random, the mark on the
screen is A.
.
all
1
1
1
1
1
27
28
29
30
POWER
STOP
PLAY/PAUSE
In play state, press PLAY/PAUSE button to pause the player. In pause state,
press PLAY/PAUSE button to start playing.
When the unit is off, press this button and hold for about 2 or 3 seconds to
turn on the power supply of the player. Repeat the above operation, you can
turn off the power supply of the player.
1
1
1
31
32
33
In play state, press STOP button to stop playing and the whole quantity
of Mp3 songs in the USB memory will display on the screen. In STOP
state, press the PRE/NEXT button or press the STOP button again to go
to the first songs and the player will keep in pause state, then press
down the PLAY/PAUSE button to play it.
NOTE
: Basic interface instruction.
When the player isn't connected to a USB memory equipment, the interface
is as follows:
11
8
12 PEAK/MUTE LED
This LED lights up when the input signal is too strong. In case of the digital
effect module being muted, this LED also lights up.
