4. INSTLATION & CONNECTION
6
(11). AC inlet
This connector is meant for the connection of the supplied main cord. Do not insert power cable into the unit
until the
rectly set.
voltage has been correctly set. Do not plug power cable into AC power until voltage has been cor
(12). MAIN INPUTS
These two XLR balanced connectors are used to input the main stereo signal. In SPLITTER mode, it can be split
into each mono channel output.
(13). MAIN OUTPUTS
These two XLR balanced connectors are used to output the main stereo signal. By depressing the MAIN LINK,
it can be linked with the MAIN IN directly.
(14). INPUT for the mono channel
For Channel 1~4, use the XLR balanced connectors to input the mono signal, while, for Channel 5~6, please
use the TRS type.
(15). OUTPUT for the mono channel
For Channel 1~4, use the XLR balanced connectors to output the mono signal, while, for Channel 5~6, please
use the TRS type.
printed next to these markers.
To change, pull fuse-holder out and rotate 180 ,then push in again.
The fuse-holder above the AC connector on the rear of the chassis has 3 triangular markers(please refer to
the above pictures), with two of these triangles opposing each other, your unit is set to the operating voltage
The mains connection of the
LTO LINK is made by using the enclosed mains cord and a standard IEC
receptacle. It meets all of the international safety certification requirements.
4.1 Mains Connection
This is a dual voltage unit. Please ensure that the
LTO LINK is set to the correct supply voltage before
plugging the power cord into the wall outlet, use the same fuse as marked on the fuse holder at the AC power
connection socket.
Do not insert power cord into the unit until voltage has been correctly set. Do not plug the power cord into AC
power until voltage has been correctly set.
4.2 Audio
onnection
C
several ways to support a variety of applications without any signal loss.
a. Wiring Configuration
unbalanced modes, which will be determined by the actual application status, Please wire your systems as the
following examples:
Either the 1/4" TRS (Tip-Ring-Sleeve) phone jack or the XLR servo connector can be wired in balanced and
The
LTO LINK presents with balanced XLR connectors and 1/4" TRS phone jack and it can be interfaced by
For 1/4" Phone jack
TS Type Unbalanced
Sleeve
Tip
+
TRS Type Balanced
Tip
Ring
Sleeve
+
-
TRS Type Unbalanced
Tip
Ring
Sleeve
+
