7
And the system Will enter into default status, showing the main operating information on the display.
Load the
containing the
you've found.
Factory PRESET
configuration
Press the
Key until the
menu LED lights up.
MODE
PRESET
The display will show the
page:
Load PRESET
Set all the MAXIDRIVE3.4 outputs in
status (LEDs lit) by pressing the relative keys.
MUTE
the PRESETS
Use the
to find the necessary Factory PRESET (indicated by the letter ). Check that if, among
DIAL
F
available, there are already some optimised for the specific speaker enclosures being used.
Press
.
ENTER
The display shows the PRESET loaded in the units memory and the relative configuration:
Proceed as follows:
Keep the MAXIDRIVE3.4 outputs in
status (LEDs light on).
MUTE
MAXIDRIVE3.4's
Feed a signal in on the
input and watch the
LED ladders.
INPUT LEVEL A-B
To obtain a good signal/noise ratio, i.e. an up-front distortion-free signal, keep the signal quite high, but make
certain the red
CLIP
LED doesn't light up continually.
MAXIDRIVE3.4
Adjust the
input gain if necessary:
Press the
key until the
menu LED lights up.
MODE
EDIT
Use the
and
keys to go to the
page:
PREV
NEXT
Input Gain
It is much more important to set the input signal of a digital unit than that of
excessively
an analog unit, because
high input signals will make
particularly distinct noise (high
any saturation of the A/D converters cause a typical
level square wave).
(example)
(example)
Press
ENTER.
The display will show the
page (according to the configuration
INA Gain or INA&B Gain
and other utilities loaded
in the memory):
A 1 3
B 2 4
S 5 6
2
F
2 x 2 W + 2 M A X
L o a d
3
F
2 x 3 W
P r e s e t
4.2 Adjusting the input signal
A 1 3
B 2 4
5
6
3
F
2 x 3 W
I n p u t
G a i n
Find out the output level setting for your mixer (or other unit) and connect it to the input of the MAXIDRIVE3.4.
