HFT2 INSTALLATION/OPERATION/SERVICE MANUAL •
3 .
s i t e i N s t A L L A t i O N
i N s t A L L A t i O N
s i t e i N s t A L L A t i O N
In order to maintain
established National
Sanitation Foundation
standards, all stationary
floor models must be
sealed to the floor with a
R.T.V. or silastic meeting
N.S.F. requirements or
have 6" (153mm)
unobstructed clearance
beneath the unit.
1. The appliance must be
installed on a stable
and level surface.
2. DO NOT install this appliance in any area
where it may be affected by any adverse
conditions such as steam, grease, dripping water,
high temperatures, or any other severely
adverse conditions.
3. DO NOT install a heated display case near a cold
air source such as a freezer, air conditioning vents,
or in any area where outside air fluctuation can
affect performance.
4. This appliance must be kept free and clear of
any obstructions blocking access for
maintenance or service.
A number of adjustments are associated with
initial installation and start-up. It is important
that these adjustments be conducted by a
qualified service technician. Installation and
start-up adjustments are the responsibility of the
dealer or user. These adjustments include but
are not limited to thermostat calibration, door
adjustment, leveling, electrical hook-up and
installation of optional casters or legs.
LeVeLiNG
Level the appliance from side-to-side and
front-to-back with the use of a spirit level.
We recommend checking the level periodically
to make certain the floor has not shifted nor the
appliance moved.
NOte:
Failure to properly level this appliance
can cause improper function.
®
D A N G e R
impROpeR inStallatiOn,
alteRatiOn, adJUStment,
SeRviCe, OR maintenanCe COUld
ReSUlt in SeveRe inJURY, deatH,
OR CaUSe pROpeRtY damage.
Read tHe inStallatiOn,
OpeRating and maintenanCe
inStRUCtiOnS tHOROUgHlY
beFORe inStalling OR SeRviCing
tHiS eQUipment.
C A u t i O N
metal paRtS OF tHiS eQUipment
beCOme eXtRemelY HOt WHen
in OpeRatiOn. tO avOid bURnS,
alWaYS USe Hand pROteCtiOn
WHen OpeRating tHiS applianCe.
C A u t i O N
tO pRevent peRSOnal inJURY,
USe CaUtiOn WHen mOving OR
leveling tHiS applianCe.
C A u t i O N
The performance of this unit has
been optimized using the factory
provided bulbs. These bulbs should
be replaced with an exact replacement
or with a factory recommended
replacement. These bulbs have been
treated to resist breakage and must be
replaced with similarly treated bulbs in
order to maintain compliance with NSF
standards. DO NOT over-tighten bulbs
in their receptacles as this can cause
damage to the bulb fi lament.
