16
MN-29250 • Rev 6 • 05/18 • Carving Station
Cleaning and Preventative Maintenance
Equipment Care
The cleanliness and appearance
of this equipment will contribute
considerably to operating
efficiency and savory, appetizing
food . Equipment that is kept clean
works better and lasts longer .
Thoroughly clean the appliance after each use
1 . Remove the food from the carving station .
2 . Set the heated surface rocker switch and the lamp
switch to the Off ( ) position . Disconnect the appliance
from the power source . Allow the appliance to cool .
3 . Remove and wash the cutting
board after each use . Sanitize
the cutting board following
applicable state or local health
sanitation ordinances . Allow the
cutting board to air dry while
lying on a clean, flat surface to
prevent warping . If the board
becomes warped, heating will
restore flexibility to facilitate flattening .
4 . Clean the exterior of the appliance with a mild soap and
water solution . Apply the solution with a clean, damp
cloth . Do not use commercial or household cleaners
that contain ammonia . Wipe with a clean, damp cloth
to remove all detergent residue . Dry with a clean, lint-
free cloth .
NOTICE:
Avoid the use of abrasive cleaning, compounds,
chloride based cleaners, or cleaners containing
quaternary salts . Never use hydrochloric acid
(muriatic acid) on stainless steel .
5 . Wipe surfaces with a sanitizing solution after cleaning
and rinsing . This solution must be approved for use on
stainless steel food contact surfaces .
6 . Clean the appliance glass with glass cleaner or distilled
vinegar .
Always follow appropriate state or local health (hygiene)
regulations regarding all applicable cleaning and
sanitation requirements for foodservice equipment .
WARNING
To prevent serious injury, death, or property
damage,
always disconnect the appliance
from the power source before cleaning
or servicing.
WARNING
To prevent serious personal injury, death, or
property damage:
Do not steam clean, hose down or flood the
interior or exterior with water or liquid solution
of any kind.
Do not use water jet to clean. Failure
to observe this precaution will void the warranty.
