MN-37010 (Rev. 8) 03/18 • Arby’s 300-TH/III Touch
•
12
Installation
AFFECTED MODELS TO INCLUDE:
ARBY’S 300-TH/III TOUCH
PURPOSE:
INSTALL AND UNINSTALL S-POD
NOTE:
SERVICE KIT 5019895
TOOLS NEEDED:
PHILLIPS HEAD SCREW DRIVER
SRV-20023 REV. 1
Alto-Shaam Technical Service 800-558-8744 x6702
1 of 2
SLIDE DOWNWARD
3
4
5
6
1
2
7
1.
Unscrew four (4) screws at corners of metal box at back of oven and remove the box.
2.
With cable connection facing the open end of the box, place S-pod inside of the box against the solid end.
3.
Slide S-pod toward open end of box so tabs at back slip over rail.
4.
Push downward on cable end of box to snap it in place.
5.
Attach cable to S-pod.
6.
Reattach box, open end down, to the back of the oven using the four (4) screws removed in Step 1.
7.
Remove red cap from port at back of oven and attach cable to port.
8.
Tighten the two (2) screws to secure the cable to the port.
PRESS TO SNAP
INTO PLACE
To Install S-pod
8
S-Pod Installation and Removal
SRV-20023 REV. 1
Alto-Shaam Technical Service 800-558-8744 x6702
S-POD INSTALLATION
2 of 2
3
4
5
6
1.
Loosen the two (2) screws to disconnect the cable from the port at the back of the oven and pull the cable from the port.
2.
Remove metal box from oven by removing the four (4) screws at the corners.
3.
Remove cable from S-pod.
4.
To remove S-pod from box, insert a screwdriver into the tab and pull outward while lifting end of S-pod.
5.
Slide S-pod toward closed end of the box to unhook tabs from top rail.
6.
Replace box at the back of the oven using the four (4) screws removed in Step 2.
To Uninstall S-pod
SLIDE UPWARD
PULL TAB OUTWARD
AND LIFT END OF
POD UPWARD
1
2
