- 6 -
5.4.2 Opening
Put the folded treadmill in a capacious position when you want to run. Then pull the
adjusting parts by hand to keep it is unlocked. Press the back part by your hands down to about
10%, release it, then it will open automatically.
6. Maintenance
6.1
Identification ways for the degree of tightness of running belt and poly V-belt.
When the running belt skips, please follow the steps as follows to make sure which belt
needs to be adjusted, running belt or poly V-belt.
a)
Cut off power, screw off the bolt on cover of protection. Then take down the protecting cover
from the treadmill
b)
Turn the speed to be around 3km/h, step on the running belt by pressure and try your best to
make the running belt stop. If running belt stops, together with the front roll, but the motor still
runs, under this condition, it means the poly V-belt needs to be adjusted.
c)
Turn the speed to be around 3km/h, step on the running belt by pressure and try your best to
make the running belt stop. If running belt stops, but front roll still runs, under this condition, it
means the running belt needs to be adjusted.
6.2 The adjustment steps for poly V-belt
Cut off power firstly and take down the cover of protection.
a)
Loosen the four screws for the motor, turn the adjustable screw(there is one screw specially
for adjust ) a circle by clockwise, then screw down the four loose screws.
b)
Keep the power on, and adjust the poly V-belt is loose or not following the point 6.1
above and too see if the v-belt is tight enough, if need to tight again, please repeat the action
same to point a) above.
6.3
Adjustment steps for running belt
a)
Turn the speed to be 5.6km/h. for running
b)
Turn the bolts at both right and left sides to be half a circuit or a circuit by the 8mm spanner.
( diagram1 and diagram 2)
c)
After adjustment, running belt still skips, please repeat the steps above.
Tighten the running belt(diagram 1) loosen the running belt(diagram 2)
6.4 The adjustment steps for running belt deflection
The running belt will be deflected more or less under using. Then it needs to be adjusted. The
steps are as follows:
a)
Place the treadmill on a horizontal floor, turn the speed to be 5.6km/h.for running.
b)
If the running belt is deflected to the right, adjust the bolt on the right by turning it for half an
