INTERFACES
12
TROUBLESHOOTING GUIDE
10
1.
When the correct voltage is applied to the
Interface, the power LED should be ON.
2.
The “Termination” dip-switch should be in the
ON position if a Y cable (breakout) is not
used on the input.
3.
Make sure the cables have the correct pin-
outs and the connection and quality of the
cables are good.
4.
Make sure that the source and display are
scan-rate compatible. The projector should
support an appropriate signal format (RGsB,
RGBS or RGBHV). Connect the projector
directly to a computer with a shorter cable to
verify the compatibility of display and source.
5. If you are using output RGBS or RGsB then
the “HV Output” dip-switch is the OFF
position and the composite sync signal is
taken from the sync connector. If the display
needs an RGBHV signal then the “HV
Output” dip-switch must be in the ON position
if the sync and vertical connectors are used.
6. If the desired output is RGsB, the sync ON
GREEN dip-switch should be ON.
ALTINEX POLICY
11
11.1 LIMITED WARRANTY
Altinex warrants that its products and cables are
free from defects in materials under normal use
and service. This warranty is limited to repairing at
company’s factory any part or parts of the product,
which upon company’s examination shall disclose
to be, thus defective. Products considered
defective should be returned to company with
transportation charges pre-paid within 2 years (90
days for cables) from date of shipment to the
purchaser. The warranty is expressly instead of all
other warranties expressed or implied. Altinex
neither assumes nor authorizes any other person
to assume for it any other liability in connection
with the sale of the products. This warranty shall
not apply to any product that shall have been
repaired or altered outside of company’s factory in
any way so as, in its judgment, to affect its
stability or reliability, or that has been subject to
misuse, negligence or accident.
11.2 RETURN POLICY
It is very important to Altinex that you receive the
products that you have ordered and that this
product fulfills your need. In the unlikely event,
that an Altinex product needs to be returned
please follow the policies below:
Altinex will accept product returns for a period of
30 days from authorized Altinex dealers. Products
must be returned in an unopened package.
If a product has been opened, the restocking fees
will apply. For the restocking fee amount, please
contact an Altinex Sales Representative.
If the product is in your possession for more than
30 days, the restocking fees will apply.
Altinex will not accept any returns on cables or
custom products.
If your product is in warranty and needs service,
contact the Altinex Sales Department for an RMA
(Return Material Authorization). Products returned
without an RMA number may experience a delay
in service.
If your product is out of warranty and needs
service, contact the Altinex Sales Department for
an RMA (Return Material Authorization). Products
returned without an RMA number may experience
a delay in service. The service charges will be
quoted to you before actual repairs are done.
11.3 CONTACT INFORMATION
Sales Department
Phone:
714-990-2300
Fax:
714-990-3303
Accounting Department
Phone:
714-990-6088
Fax:
714-990-5778
Summary of Contents for VA6835FC
Page 6: ...INTERFACES 5...
