Under the Table Interconnect Solutions
User’s Guide
400-0596-001
1
Installation Options
Welcome!
Everyone at Altinex greatly appreciates your UT240-121S
purchase. We are confident you will find it to be reliable and easy
to use. If you need support, do not hesitate to call at
714-990-2300.
We are committed to developing unique, state of the art Signal
Management Solutions
®
for demanding audiovisual installations.
Welcome to Altinex’s family of satisfied customers worldwide!
1. Precautions and Safety Warnings
Please read this manual carefully before using your UT240-121S
Cable-Nook Interconnect Box. Keep this manual handy for future
reference. These safety instructions are to ensure the long life of
your UT240-121S and to prevent fire and shock hazards. Please
read them carefully and heed all warnings.
1.1 General
•
Qualified Altinex service personnel or their authorized
representatives must perform all service.
1.2 Installation
•
For best results, place in a dry area away from dust and
moisture.
•
To prevent fire or shock, do not expose unit to water or
moisture. Do not place UT240-121S in direct sunlight, near
heaters or heat-radiating appliances, or near any liquid.
Exposure to direct sunlight, smoke, or steam can harm
internal components.
•
Handle carefully; dropping or jarring can damage the unit.
•
Do not pull any cables that are attached to the UT240-121S.
•
Install all cables according to the instructions.
1.3 Cleaning
•
Clean surfaces with a dry cloth. Never use strong
detergents or solvents such as alcohol or thinner. Do not
use a wet cloth or water to clean the unit.
1.4 FCC Notice
•
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this
device must accept any interference received, including
interference that may cause undesired operation.
•
This equipment has been tested and found to comply with
the limits for a Class A digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference when the
equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency
energy and if not installed and used in accordance with
instructions found herein, may cause harmful interference to
radio communications. Operation of this equipment in a
residential area is likely to cause harmful interference in
which case the user will be required to correct the
interference at his own expense.
•
Any changes or modifications to the unit not expressly
approved by Altinex, Inc. could void the user’s authority to
operate the equipment.
_______________________________________________________________________________________________________________________________________
2. Installation Procedures
The UT240-121S can be installed horizontally or vertically as shown.
Step 1. Locate the best position for the UT240-121S, but do NOT install until cables are ready.
Step 2. Prepare the mating cables using high-quality cables for best results and durability. Make the
cables long enough to allow for a service-loop and so the cables can be neatly routed.
Step 3. Prepare network cables using the CAT-6 (RJ-45) connectors provided with the unit. They are
high-quality snap-in connectors and do not require any tools for installing them into the UT
interconnect.
Step 4. Secure the unit under the table using the metal screws provided with the unit.
Step 5. Make any necessary connections to the snap-in connectors.
Step 6. Use cable-ties to secure the cables to the mounting shelf. Insert the ties through the holes on
the bottom of the unit. Use the cable clamps provided to secure the cables to the
bottom of the table/desk.
3. Limited Warranty/Return Policies
Please visit the Altinex website at
return policies.
Note: Connectors are provided but do not include
cables. ALTINEX recommends a
telecommunications contractor wire the
network connectors and verify operation
before installing the UT240-121S.
