TNP355C INTERCONNECT BOX
User’s Guide
400-0615-001
1
Welcome!
We greatly appreciate your purchase of your TNP355C Series
Tilt 'N Plug. We are sure you will find it reliable and simple to
use. We are committed to providing Signal Management
Solutions® to our customers for the most demanding
audiovisual installations at competitive pricing and we welcome
you to join the ranks of our many satisfied customers
throughout the world.
1. Precautions and Safety Warnings
Please read this manual carefully before using your Tilt 'N
Plug. Interconnect Box. Keep this manual handy for future
reference. These safety instructions are to ensure the long life
of your Tilt 'N Plug and to prevent fire and shock hazards.
Please read them carefully and heed all warnings.
1.1 General
Unauthorized personnel shall not open the unit as there
are high-voltage components inside. Only qualified Altinex
service personnel or their authorized representatives must
perform all service.
1.2 Installation Precautions
For best results, place the Tilt 'N Plug in a dry area away
from dust.
To prevent fire or shock, do not expose this unit to water
or moisture. Do not place the unit in direct sunlight, near
heaters or heat-radiating appliances, or near any liquid.
Exposure to direct sunlight, smoke, or steam can harm
internal components.
Handle carefully; dropping or jarring can damage the
bezel.
Never place fingers inside the opening on either side of
the unit. This action could cause injury due to sharp edges
inside.
Do not place heavy objects on top of the Tilt 'N Plug. Do
not use excessive force to push down on the top of the
unit.
Disconnect the power cord to turn off the power. This
supplies power to the socket on the pop-up panel. The
power outlet should be installed near the equipment and
be easily accessible.
Install all cables according to the instructions found herein.
Do not force or pull any cable that is attached to the Tilt 'N
Plug.
1.3 Cleaning
Surfaces should be cleaned with a dry cloth. Never use
strong detergents or solvents such as alcohol or thinner.
2. Installation Procedures
Step 1
Cut an opening into the table
’s surface. Refer to the ALTINEX website at
http://www.altinex.com/
for table cutout requirements.
NOTE:
The table can be 2.25 in (57 mm) or less in thickness. Always confirm
dimensions before cutting to insure that specifications have not changed.
Step 2
Insert the TNP355C into the table cutout.
Step 3
Place the support brackets under the table and place them between the support
mount grooves on the side of the unit. Attach the brackets to the groove at the
desired height and secure them to the bottom of the table using the knurled
table securing screws provided with the additional wing nuts for added
tightening.
Step 4
To lower the unit, push on the top cover until it locks into place.
Step 5
Secure power cable to the underside of the table using the cable clamps and screws included with the TNP. Pass the
power cord from the bottom of the housing and attach it to the table separate from the signal cables. Leave enough slack
in the service loop to allow for easy opening and closing, but not too much as to cause excess drooping of the service
loop.
Step 6
Once you have applied power on the bottom of the unit you may raise the unit. To raise the unit into position, push down
on the front of the top cover; the latching mechanism will then release, allowing the pneumatic spring to raise it into
position.
NOTE:
It may be necessary to adjust the service loop of the cable for optimal performance.
3. Limited Warranty/Return Policies
Please see the ALTINEX website at www.altinex.com for details on warranty and return policies.
