DESIGNER SOLUTIONS
400-0109-006
11
DIAGRAM 7: ACCESSORY INSTALLATION
Feed any cables attached to the sectional plate through the front of the PNP400, then
down through the opening in the bottom of the chassis. Make sure the cables exit the
chassis on the same side as the plate. They should NOT cross over the center of the unit.
Align the mounting holes of the sectional plate and PNP400 chassis.
Use the plastic rivets supplied with the sectional plate to fasten the sectional plate to the
chassis. A rivet tool is supplied with the PNP400.
FEED CABLES
THROUGH FRONT
THROUGH CHASSIS
AND DOWN
HOLES
ALIGN MOUNTING
FASTEN WITH
PLASTIC RIVETS
(SP3201AV shown here.)
Insert this side
through holes
until it sits flush
with the metal.
Insert this side
all the way
down until it
sits flush with
dome surface.
PLASTIC RIVETS
AFTER
BEFORE
1
2
3
The plastic rivets may be removed by pressing
the center pin all the way through the material
using a small screwdriver. Then use small pliers
to remove the plastic, being careful not to scratch
the metal.
NOTE:
Summary of Contents for Pop 'N Plug Tower PNP400
