DISTRBUTION AMPLIFIERS
7
VGA TO RGB ADAPTER CABLES
MS8102CA
15-pin HD Male to 5 BNC Male, 6ft
MS8104CA
15-pin HD Male to 5 BNC Male, 15ft
MS8105CA
15-pin HD Male to 5 BNC Male, 50 ft
MS8112CA
15-pin HD Female to 5 BNC Male, 6ft
MS8114CA
15-pin HD Female to 5 BNC Male, 15ft
POWER CABLES
PS5301US
Power Cable for US
PS5302UK
Power Cable for UK
PS5303AU
Power Cable for Australia
PS5304GR
Germany
FREQUENTLY ASKED QUESTIONS
9
No:
Question
Answer
1
How many
feet of cable
may I use
with
the
DA1322AT
?
The
DA1322AT
offers
individual channel adjustment
for gain and peaking, allowing
specific control over the
outputs for different lengths
of cable.
2
Are the
outputs of
the
DA1322AT
buffered?
Yes, the
DA1322AT
offers
two individually buffered
outputs.
3
What is
meant by
buffered
output?
Buffered output means that
the output signal is isolated
from the input signal. The
loaded output does not affect
the input, or any other output
on the device. A buffered
output may vary in terms of
the gain or peaking
adjustments made to the
video signal
4
If the input
of the
DA1322AT
provides an
RGBHV
format
signal what
is available
on the
output?
The
DA1322AT
offers sync
combining and separating
functions. If the input
provides RGBHV, on the
output you may have RGBS,
You may also have RGBS on
the input and RGBHV on the
output.
5
May I use
You can not use cat 5 cable
cat 5 cable
instead of
coaxial
cable?
instead coaxial cable,
because you will loose the
quality of the receiving signal.
Due to this, we do not have
isolation of each wire; the
signals will interfere with each
other.
6
What is the
maximum
resolution I
can pass
through
the
DA1322AT
?
Resolution format describes
the number of pixels and lines
in a given video image, as
well as the rate at which each
frame is re-drawn or
refreshed. Offering a
minimum video bandwidth of
350 MHz and typical
bandwidth close 500 MHz,
the
DA1322AT
allows even
very high resolution video
signals to pass without
degrading the image quality.
TROUBLESHOOTING GUIDE
10
We have carefully tested and have found no
problems in supplied the
DA1322AT
unit; however,
we would like to offer the following suggestions:
•
Please make sure that input amplitude of the
analog signal is less than 1.5V.
•
Please make sure that the proper quality of
cables is used. We recommend Altinex made
cables for best results.
•
If a problem shows up after continuous usage at
higher voltage, higher temperature, higher
humidity, or at other extreme environmental
conditions, please correct the problem. NOTE:
The sync pulse voltage must be at least 1.4 volts
for proper operation of the distribution amplifier.
If lower voltage is used, contact Altinex for
additional information.
