Visit our website at www.fantomskateboard.com for replacement parts and technical support.
9
Operating
PREPARATION
Be sure that you are thoroughly familiar with all of the features and controls
explained in this manual before you ride.
ADJUST THE BOARD’S SPEED-ACCELERATION PERFORMANCE
Your board has 3 adjustable speed/acceleration ranges. Factory preset is the middle
position favored by most riders. To change (1) Turn off the wireless remote. (2) Remove
battery cover from base of remote. (3) Set the slide switch according to these guidelines.
Slide switch
shown in Middle
position
- Middle Position - Full speed/controlled acceleration
Recommended for most riders, this factory preset
setting offers top speed but will accelerate more
gradually to help keep a rider on the board during
sudden trigger squeezes.
- Far Right Position - Full speed/full throttle control
Recommended for only the most experienced riders
offers acceleration in direct response to trigger
pressure. Sudden trigger squeezes result in immediate
acceleration – full, direct control so be careful!
- Far Left Position - Low speed maximum
Recommended for beginners and anyone who wants a
slower, more controlled speed.
POWER ON – BOARD LINKS & LOCKS-ON TO REMOTE CONTROL
Each board comes “paired” to the remote control unit that is shipped with the board. Each
time you turn on your board and remote they will search to find each other and link/lock-
on. Follow these steps to get started (one board at a time if in a group)
1 - Press the board power switch (A) to the “On”
Position. The LED will turn red after 3 seconds –
the board is ready to link to your remote control.
2 - Turn on the remote control (B). The remote’s
red LED will flash & tone confirming remote is
powered.
- After 4 seconds remote LED turns on showing
board is linked. (LED will begin to flash every 2-3
seconds, showing board is linked.)
- Skateboard LED Skateboard LED’s will display
one green, one red light once properly linked.
A
B
