Chapter 2: Cyclone IV Reset Control and Power Down
2–19
Dynamic Reconfiguration Reset Sequences
September 2014
Altera Corporation
Dynamic Reconfiguration Reset Sequences
When using dynamic reconfiguration in data rate divisions in PLL reconfiguration or
channel reconfiguration mode, use the following reset sequences.
Reset Sequence in PLL Reconfiguration Mode
Use the example reset sequence shown in
reconfiguration controller to change the data rate of the transceiver channel. In this
example, PLL dynamic reconfiguration is used to dynamically reconfigure the data
rate of the transceiver channel configured in Basic ×1 mode with the receiver CDR in
automatic lock mode.
As shown in
, perform the following reset procedure when using the PLL
dynamic reconfiguration controller to change the configuration of the PLLs in the
transmitter channel:
1. Assert the
tx_digitalreset
,
rx_analogreset
, and
rx_digitalreset
signals. The
pll_configupdate
signal is asserted (marker 1) by the ALTPLL_RECONFIG
megafunction after the final data bit is sent out. The
pll_reconfig_done
signal is
asserted (marker 2) to inform the ALTPLL_RECONFIG megafunction that the scan
chain process is completed. The ALTPLL_RECONFIG megafunction then asserts
the
pll_areset
signal (marker 3) to reset the transceiver PLL.
Figure 2–11. Reset Sequence When Using the PLL Dynamic Reconfiguration Controller to Change
the Data Rate of the Transceiver Channel
Notes to
(1) The
pll_configupdate
and
pll_areset
signals are driven by the ALTPLL_RECONFIG megafunction. For more
information, refer to
AN 609: Implementing Dynamic Reconfiguration in Cyclone IV GX Devices
chapter.
(2) For t
LTD_Auto
duration, refer to the
Output Status Signals
pll_reconfig_done
5
tx_digitalreset
pll_configupdate
(1)
Reset and Control Signals
rx_analogreset
8
rx_digitalreset
pll_locked
3
pll_areset
(1)
1
2
6
t
LTD_Auto
(2)
4
Five parallel clock cycles
rx_freqlocked
7
Summary of Contents for Cyclone IV
