Altera Cyclone III, Getting Started Manual

Page: 19 / 34

Chapter 4: DSP Development Kit Hardware Setup 4–5
Powering up the Board
© August 2008 Altera Corporation DSP Development Kit, Cyclone III Edition Getting Started User Guide
Preliminary
4. Ensure that the 4-position SW3 mini-DIP switches and the two jumpers are set to
the default positions shown in Table 4–2 .
5. Verify that the PGM CONFIG SELECT rotary switch SW5 is set to 0.
On power up, the development board uses a preloaded configuration to
demonstrate that the board is operating correctly.
6. Connect the Data Conversion HSMC to HSMC Port A on the left side of the
development board.
7. Verify the jumper configuration is set to the following default settings:
■
J2 ADC_A POWER DOWN removed
■
J3 ADC_A CK SEL jumpers on pins 1-3 and 4-6
■
J6 ADC_B POWER DOWN removed
■
J7 ADC_B CK SEL jumpers on pins 1-3 and 4-6
■
J10 DAC GSET removed
■
J11 DAC MODE removed
■
J13 DAC SLEEP removed
■
J15 DAC_A CLK SEL jumpers on pins 1-3 and 4-6
■
J17 DAC_B CLK SEL jumpers on pins 1-3 and 4-6
■
J23 CLK OUT SEL jumpers on pins 1-3 and 2-4
8. Set the user dip switches on the Cyclone III development board with all of the
switches open.
Table 4–1. Switch SW1 Settings
Switch Name
Function
Default Position Position 0 Position 1
1 mW/mA mW mA 0
2 V/W V W 1
3 RSV0
MAX_RESERVE0
X
4 RSV1
MAX_RESERVE1
X
5 MAX0 PFL Disable PFL Enable 1
6 MAX1
MAX_DIP1
X
7 MAX2
MAX_DIP2
X
8 MAX3
MAX_DIP3
X
Note to Table 4–1 :
(1) X = don’t care
Table 4–2. Initial Switch and Jump Settings
DEV_SEL-J6 JTAG_SEL-J7 SW3.1 SW3.2 SW3.3 SW3.4
ON ON ON OFF OFF OFF