6
SPECIFICATIONS
System Response
20 – 20 kHz
Total Audio Power
40 Watts
Input Impedance
>10k Ohms
Input Sensitivity
300 mV for full output
SET TOP AMPLIFIERS/SPEAKERS
Drivers Four 3” full range
Power
20 Watts (5 watts per driver)
at 0.8% THD
Signal-to-Noise Ratio
>70dB
SUBWOOFER
Driver
One 6 1/2” dual voice coil
Power
20 Watts at 0.8% THD
Crossover Frequency
150 Hz
Signal-to-Noise Ratio
>70 dB
USA/Canada Current 120V/120W/60Hz
Replace fuse if required only with a 1 AMP “Slow Blow” 250V Rating.
Size 5 x 20mm.
Europe/United Kingdom and 230V/240W/50Hz
Various Asian Countries
Replace fuse if required only with a T500 MA Rating. Size 5 x 20mm.
UL/CUL/CE approved
PLACEMENT OF SPEAKERS
For best performance the TV set top speaker should be centered and
brought as far forward on the TV set as is practical. Remove any articles
that can vibrate and cause distortion.
The subwoofer can be placed in any convenient location as far as the
connecting cables will allow. Subwoofer frequencies are non
directional, therefore the subwoofer can be placed on either side of the
TV set. The subwoofer can be forward or back in relationship to the set
top speakers. Best low frequency response is obtained when the
subwoofer is placed on the floor. The subwoofer speaker IS NOT
magnetically shielded and should not be placed in close proximity to
the TV screen; otherwise image distortion may occur.
The TV set top speaker has adjustable feet so that the speakers can be
angled for best directivity of sound.
Summary of Contents for ADA104
Page 2: ...2 ...
