Remove the wand hanger from the headrail. Squeeze the bottom on both sides to
release the lower legs. Lift up slightly and remove the hanger post from the top hole in
the headrail.
Attach the “Internal L Hanger” onto the “Hanger Post”, ensure the “Internal L Hanger”
is behind the tip of the screw.
Insert the post into the top hole in the headrail first. Then, squeeze the bottom of the
hanger on b
oth sides so that the lower legs will fit into the hole in the headrail. Make
sure that the wires are not in the way of the legs.
Plug the control wire into the wand wire. The plugs will only fit together one way.
Use a flat head screwdriver to tighten the wand cap screw into the headrail.
NOTE:
It may be necessary to hold the cap against the headrail while turning the
screw to fasten the wand cap securely.
4
To remove a shade, insert a screwdriver between the head rail and the bottom back of the
bracket (tab which extends out slightly from each bracket).
Gently pry the screwdriver to release the bracket from the headrail. Take care not to damage
the painted finish of the headrail.
As you release the brackets, support the headrail to keep it from falling.
• With the front side of the shade facing you…
• Tilt the headrail slightly backward to angle the front inside lip to the brackets (A).
• Push the headrail back and upward to snap in it into place (B).
Make sure that no fabric is pinched between the brackets and the headrail.
Insert screwdriver
here and gently pry
Internal L
Hanger
Hanger
Post
Lower Legs
Push here upward
and toward the window
Installing the Wand
Removing the Shade
Installaling the Shade
