Assembly instructions for LED panel
Carefully remove the LED panel from its packaging.
Over the corner edge of the light carefully put it into the ceiling section.
Avoid mechanical tensions on panel, the light should have some space.
Turn Off power supply before starting any installation.
Do not connect the device under power.
Connect the supply cables according to the electrical regulations to the
primary connection 230V AC to LED converter.
The electrical connection from LED panel to the converter is connected with
a plug-in connector.
Do not unplug
before switching on, also not during
operating the lamp.
Only use the supplied LED converter! Other converters or transformers may
destroy the light.
In case of ceiling installation place LED converter
sideways
to the light.
Insert the connector and tighten.
It is not allowed to cover LED panel and LED converter with heatinsu-
lating cover sheet or similar materials!
Additional drillings in the LED luminaire are not allowed!
Do not place the LED converter on the LED pendant luminaire to avoid
unnecessary transfer of heat.
Another installation / assembly / materials / types than provided in the
manual sheets, release us from any electrotechnical and electrostatic
responsibility.
Fixing materials:
Pendant mounting order number: Z-ELEDN
Assembly frame order number: ELED2-AUR42
The warranty is void if the buyer or a third party repairs or modifies the
luminaire.
For further information please check out remote control manual
Z-FBELEDN.
X
