Alpine STi Series Gas Fireplaces
17
This appliance must be installed in accordance with local codes, if any;
If not, follow the current ANSI Z223.1
WARNING: If you do not follow these instructions exactly, a fire or
explosion may result causing property damage, personal injury or loss of
life. Improper installation, adjustment, alteration, service or maintenance
can cause injury or property damage. Refer to the owner’s information
manual provided with this appliance. For assistance or additional
information consult a qualified installer, service agency or gas supplier.
A) This appliance has a pilot which must
be lighted by hand. When lighting the
pilot, follow these instructions exactly.
B) BEFORE LIGHTING smell all around
the appliance area for gas. Be sure to
smell next to the floor because some
gas is heavier than air and will settle
on the floor.
WHAT TO DO IF YOU SMELL GAS
−
Do not try to light any appliance
−
Do not touch any electrical switch, do
not use any phone in your building.
−
Immediately call your gas supplier from
a neighbors phone. Follow the gas
suppliers instructions.
−
If you cannot reach your gas supplier,
call the fire department.
C) Use only your hand to push in or
turn the gas control knob. Never use
tools. If the knob will not push in or
turn hand, don’t try to repair it, call
a qualified service technician. Force
or attempted repair may result in a
fire or explosion.
D) Do not use this appliance if any part
has been under water. Immediately
call a qualified service technician to
inspect the appliance and to replace
any part of the control system and
any gas control which has been
under water.
This appliance needs fresh air for safe
operation and must be installed so there are
provisions for adequate combustion and
ventilation air.
CAUTION: Hot while in operation. Do not touch. Keep children, clothing,
furniture, gasoline and other liquids having flammable vapors away. Keep
burner and control compartment clean. See installation and operating
instructions accompanying appliance.
LIGHTING INSTRUCTIONS
STOP! Read the safety information above on
this label.
1) Push in gas control knob slightly and turn
clockwise
C
to “OFF”. Knob cannot be
turned from “PILOT” to “OFF” unless
knob is pushed in slightly. Do not force.
2) Wait five (5) minutes to clear out any gas.
If you then smell gas STOP! Follow “B”
in the safety information above on this
label. If you don’t smell gas, go to the next
step.
3)
Turn knob on the gas control
4) Push in control knob all the way and hold
in. Continually push and release the red
button on the spark ignitor until pilot
lights. Continue to hold the control knob
in for about 1/2 minute after the pilot is
lit. Release knob and it will pop back up.
Pilot should remain lit. If it goes out,
repeat steps 1 to 4. If knob does not pop
up when released, stop and immediately
call your service technician or gas
supplier. If the pilot will not stay lit after
several tries, turn the gas control knob to
“OFF” and call your service technician or
gas supplier.
5) Turn gas control knob counterclockwise
D
to “ON”
6) Use the toggle switch to operate main
burner.
TO TURN OFF GAS APPLIANCE
1) Push in the gas control knob slightly and
turn clockwise
C
to “OFF”. Do not force.
2) Turn off all electric power to the appliance
if service is to be performed.
DO NOT REMOVE THIS INSTRUCTION PLATE
DVI-700-1
FOR YOUR SAFETY READ BEFORE LIGHTING
Clockwise to “OFF”
C
Pilot Burner
THERMOPILE
OPERATING INSTRUCTIONS
