•
Re-Install the lens and lens retainer ensuring the “O” ring remains in the correct position in the
groove of the Power Beam™ Light.
•
To maintain a good water tight seal, make sure the lens is flush with the front lip of the rubber
seal.
•
To change your Power Beam™ color lens, remove the lens and replace it with a colored lens of
your choice.
•
Make sure the lens is on the rubber seal then take the cover and place it correctly onto the slots of
the Power Beam™ turning tightly clockwise.
•
Make sure the cover is tightly locked.
Limited Warranty Information:
For complete limited warranty information and details, please visit our
website at www.alpine4u.com
Troubleshooting your Power Beam™:
If light fails to illuminate, please check the following:
•
Check that the light set is getting power by testing another applicant in the power outlet that the lights use
•
Check to ensure that your light bulb has not burned out from usage
•
If water gets into any of your Power Beam™ lights, lift it out of the water, remove the lens and empty the
water until dry
Caution & Warning:
•
Always handle the light from the base. The light housing can and will become HOT!
•
Operating the lights with missing or damaged covers can result in risk of fire or electrical shock
•
Use ONLY recommended MR11 12 volt 20 watt halogen bulbs
•
Do not exceed the voltage & wattage indicated on the transformer
•
Keep away from flammable and/or children
•
This light assembly has not been tested or deigned for use in swimming pools and hot tubs
•
This light has been designed and made for underwater use only, if not submerged damage to light may
occur
