INA-W900 /
INA-W900BT /
INA-W910 /
INA-NAV-10 /
INA-NAV-20
AVN
System
Wiring Harness Diagram
To
Foot Brake
(+)
at switch above
pedal
To
Parking Brake
(-) at the parking
brake in drivers kick
panel
To Chevrolet
Camaro Vehicle
Harness
* No connection for INA-W910;
Bluetooth® module optional for INA-W900;
KCE-250BT module included with the INA-W900BT.
10A
To Bluetooth® Module
Power Connector
To Steering Remote
Input (Pigtail)
To Head Unit Power
Connector
Yellow/Blue
Yellow/Black
7.5A
KCE-250BT or
KCE-400BT
Bluetooth®
Module*
Blue/White
To Orange/White On
Back Of Radio
To aftermarket
amplifier remote
turn on
USB for interface
firmware update only
Vehicle Startup
Connection And Initialization Procedure:
IMPORTANT NOTE!
The connection and startup process below must be followed, or the
HVAC touch screen system may not operate properly.
1. Re-route factory HVAC connector to radio cavity.
2. Connect factory radio connector to Alpine harness.
3. Connect factory HVAC connector to Alpine harness.
4. IF USING OPTIONAL OnStar® MODULE: Remove looped 20 pin connector from Alpine
harness and connect OnStar® module*.
5. Move OnStar® module, radio connector, and HVAC connector to the left of the radio cav
-
ity.
6. Route the 8 and 24 pin connectors of Alpine harness to original location of HVAC connec
-
tor.
7. Connect the Alpine harness along with antenna and all other accessories to the aftermar
-
ket radio and insert into radio cavity.
8. Enter the car and shut all doors and remove the key.
9. Wait approximately 5 minutes for the vehicles computer to enter a sleep state (approx. 2
minutes after dome light turns off).
1 0. You may now connect the 24 pin and 8 pin connectors to the new HVAC controller.
11. While still in the vehicle with the doors shut, insert the key and start the vehicle’s engine.
*THE OnStar® MODULE MUST BE CONNECTED BEFORE THE NEW HVAC CONTROLLER
CAN BE CONNECTED.*
Non-Onstar
(Bypass Plug)
KCX-OSMGM
for vehicles with On
-
Star® (Sold Separately)
To Touch Screen
Module in Kit
3