49
-EN
The PXA-H700 or PXA-H701 can be set according to the playable
frequency range of your speakers.
Check the playable frequency range of the speakers (not including the
subwoofer) before performing this operation to verify whether the
speakers can play low frequencies (of about 80 Hz or less).
•
Avoid stopping, pausing, switching the disc, cueing, fast-forwarding
or switching the audio channel of this unit while making this
adjustment. The setting is cancelled if Decode mode is switched.
Setting item: SPEAKER SETUP
Select the speaker characteristic by touching
[
]
,
[
]
of
the desired speaker setting.
*
1
It is not possible to set the front speakers to “OFF”.
*
2
If the front speakers are set to “SMALL”, the rear and centre
speakers cannot be set to “LARGE”.
•
The subwoofer can be set only to ON/OFF.
•
If the centre speaker is turned “OFF”, the centre channel’s audio
signals are added to the audio signals output from the front speakers.
•
If you set the speaker response to “OFF”, also set the speaker setting
to “OFF” (page 48).
•
Perform the setup for all the speakers (“Front”, “Centre” ,“Rear”
and “Subwoofer”). If not, the sound may not be balanced.
•
When centre is set to “OFF”, the setting is ineffective even if centre
is set with this function.
•
Through changing the settings on each speaker, a change in the
output of the other speakers may occur due to the setting
requirements.
•
When using the PRO LOGIC II, if the rear speaker is set to
“LARGE”, then there will be no output from the subwoofer.
The volume (signal level) for Dolby Digital, Dolby PL II, DTS and
PCM modes can be set.
•
Avoid stopping, pausing, switching the disc, cueing, fast-forwarding
or switching the audio channel of this unit while making this
adjustment. The setting is cancelled if the Decode mode is switched.
Setting item: DVD LEVEL
Adjust the level by touching
[
]
or
[
]
of the desired
adjusting mode.
The level can be adjusted in the range of –5 dB to +5 dB.
The output when playing discs recorded in linear PCM can be set to 2 or
3 channels.
Setting item: PCM MODE
Touch
[
]
or
[
]
of PCM MODE to select 2CH or 3CH.
•
This adjustment is ineffective when the speaker is set CENTER to
OFF in “Setting the Speakers” (page 48).
Storing Settings in the Memory
Adjustment or setting contents can be stored.
Contents that can be stored vary depends on the audio processor used.
1
Touch
[MEMORY]
on the A.PROCESSOR list
display.
2
Within 5 seconds, touch any one of the preset
buttons
[P.SET 1]
through
[P.SET 6]
on the
A.PROCESSOR list screen.
The setting contents are stored.
•
The stored contents will not be deleted even when the battery power
cord is detached.
Calling up the Preset Memory
Touch any one of the preset buttons
[P.SET 1]
through
[P.SET 6]
on the A.PROCESSOR list display to select
the preset memory.
•
It takes a few moments to call up the preset memory.
Speaker Setup
OFF
*
1
:
When no speaker is connected.
SMALL:
When a speaker that cannot play low frequencies
(80 Hz or less) is connected.
LARGE
*
2
:
When a speaker that can play low frequencies
(80 Hz or less) is connected.
Adjusting the DVD Level
Linear PCM Setting
2CH:
2ch output (L/R)
3CH:
3ch output (L/R/CENTER)
Summary of Contents for IVA-W502R
Page 2: ......
