3
-EN
Precautions
• Be sure to disconnect the cable from the (–) battery post
before installing your unit. This will reduce any chance of
damage to the unit in case of a short-circuit.
• Be sure to connect the color coded leads according to
the diagram. Incorrect connections may cause the unit to
malfunction or damage to the vehicle’s electrical system.
• When making connections to the vehicle’s electrical
system, be aware of the factory installed components (e.g.
on-board computer). Do not tap into these leads to provide
power for this unit. When connecting the unit to the fuse
box, make sure the fuse for the intended circuit of the unit
has the appropriate amperage. When in doubt, consult
your Alpine dealer.
• Be sure to connect the speaker (–) leads to the speaker
(–) terminal. Never connect left and right channel speaker
cables to each other or to the vehicle body.
Accessory List
• INE-W611D....................................................................... 1
• Power cable.................................................................... 1
• GPS Antenna.................................................................. 1
• Antenna mounting plate................................................. 1
• Cable clamp for antenna........................................... 1set
• USB extension cable...................................................... 2
• PRE OUT cable.............................................................. 1
• Microphone..................................................................... 1
• Interface cable................................................................ 1
• Inner case............................................................................ 1
• Face plate............................................................................ 1
• Inner case release key....................................................... 2
• Flush Head Screw (M5 8mm)........................................... 6
• Screw (M5 8mm)............................................................... 8
• Rubber cap(only INE-W611D)............................................1
• Hex Bolt(only INE-W611D)..................................................1
• Owner’s Manual........................................................... 1set
Installation
To install refer to the manual in the separately
purchased installation kit for each car type.
Caution
Do not block the unit’s fan, thus preventing air circulation. If
blocked, heat will accumulate inside the unit and may cause a fire.
<example>
Air ventilation hole
Rear of the Unit
Caution concerning the installation location
Angle of installation
Install at an angle between horizontal and 30°. Note that
installing at an angle outside of this range will result in a loss
of performance and possibly damage.
0 - 30°
Mounting the GPS Antenna inside the vehicle
1
Clean the mounting location.
2
Put on the GPS Antenna mounting plate.
3
Mount the GPS Antenna.
• Do not mount the GPS Antenna inside the center
console.
- Mount the GPS Antenna on a flat plane of the dash
board or rear tray.
- Make sure the GPS Antenna is not covered
(obstructed) by any metallic surface or object.
• If the GPS Antenna is mounted near the unit, the
reception becomes poor, and the location of your
vehicle may not be displayed correctly.
- Mount the GPS Antenna far away enough from the
unit.
- Bundle the GPS Antenna cable away from the rear of
the unit.
•
Some thermal reflection type or thermal absorption type
glass may interrupt high frequency waves. If reception
is poor with the antenna installed inside the car, try to
mount the antenna outside the car.
GPS Antenna
Antenna mounting plate
This unit
