26
-EN
01GB05iDAX305.fm
ALPINE iDA-X305 68-13530Z16-A (EN)
Adjusting the Time Correction
Sound Field Adjustment
Time Correction
Before performing the following procedures, refer to “About Time
Correction” (page 28).
1
Rotate the
Double Action encoder
to select “Time
Correction” in the Sound Field adjustment mode,
and then press
/ENTER
.
Depending on the X-OVER switch setting on the IMPRINT
audio processor (PXA-H100), the speaker to be adjusted
differs.
3WAY System
F/R/SUBW. System
2
Rotate the
Double Action encoder
to select the
speaker, and press
/ENTER
.
3
Rotate the
Double Action encoder
to set to the
distance of each speaker.
0.0 cm~336.6 cm (0.0 inch~132.7 inch)
4
If
/ENTER
is pressed, the adjustment value is
set, and the speaker selection mode is activated.
5
Repeat steps 2 to 4, and set the all speakers.
•
During adjustment, if you press in the outer ring and rotate the
Double Action encoder
to the left or right, the speaker changes, and
you can adjust the adjacent speaker. If you press then rotate and hold
the
Double Action encoder
to the left or right, the speaker
continuously changes.
You can also change the speaker by pressing
BAND
.
Adjusting the Crossover Settings
Sound Field Adjustment
X-Over
Before performing the following procedures, refer to “About the
Crossover” (page 29).
1
Rotate the
Double Action encoder
to select
“X-Over” in the Sound Field adjustment mode, and
then press
/ENTER
.
2
Rotate the
Double Action encoder
to select the
band, and then press
/ENTER
.
If a band is selected, each band screen to be adjusted is
displayed.
3WAY System / Normal (L=R)
Setting items:
Low/Mid-Low/Mid-High/High
3WAY System / Individual (L/R)
Setting items:
Low L/Low R/Mid-Low L/Mid-Low R/Mid-High L/
Mid-High R/High L/High R
F/R/SUBW. System / Normal (L=R)
Setting items:
Subw./Rear/Front
F/R/SUBW. System / Individual (L/R)
Setting items:
Subw. L/Subw. R/Rear L/Reat R/Front L/Front R
•
Depending on the current system, selectable band content differs.
Refer to “Setting the Filter type” (page 25) and the setting of the
X-OVER switch on the IMPRINT audio processor (PXA-H100).
3
Rotate the
Double Action encoder
to adjust the
frequency/slope/level.
The currently adjusted item lights up.
4
The adjustment content is selected by pressing
/ENTER
, and operation shifts to a next
adjustment item.
5
When the selected band settings are complete,
press
BAND
.
The next band adjustment screen is displayed.
6
Set all bands by repeating steps 3 to 5.
High L / High R / Mid L / Mid R / Low L / Low R
Front L / Front R / Rear L / Rear R / Subw. L / Subw. R
Selected
speakers
Level
Cut-off
frequency
Slope
Band
01GB00iDAX305.book Page 26 Thursday, September 18, 2008 9:55 AM
