6
-EN
iDA-X303
iDA-X301/iDA-X301RR
Accessory List
•
Digital Media receiver........................................................1
•
Power cable ........................................................................1
•
USB Cable ..........................................................................1
•
Interface cable for iPod (iDA-X303 only) ..........................1
•
FULL SPEED™ Connection Cable
(iDA-X301/iDA-X301RR only) ............................................1
•
Mounting sleeve.................................................................1
•
Carrying case .....................................................................1
•
Rubber Cap ........................................…………………….. 1
•
Hex Bolt ........................................ ………………………... 1
•
Screw (M5x8)......................................................................4
•
Owner’s Manual .......................................................... 1 set
Turning Power On and Off
Press
SOURCE
to turn on the unit.
•
The unit can be turned on by pressing any other button except
(Release) and Double Action encoder (iDA-X303 only). The unit
is also automatically turned on if a USB memory/iPhone*/iPod* is
connected to the USB connector.
* iDA-X303 only.
Press and hold
SOURCE
for at least 2 seconds to turn
off the unit.
•
The first time power is turned on, the volume will start from level 12.
Detaching and Attaching the Front Panel
Detaching
1
Turn off the unit power.
2
Press
(Release)
at the middle left side until the
front panel pops out.
3
Grasp the left side of the front panel and pull it out.
•
The front panel may become hot in normal usage (especially the
connector terminals on the back of the front panel.) This is not a
malfunction.
•
To protect the front panel, place it in the supplied carrying case.
Attaching
1
Insert the right side of the front panel into the main
unit. Align the groove on the front panel with the
projections on the main unit.
2
Push the left side of the front panel until it locks
firmly into the main unit.
•
Before attaching the front panel, make sure that there is no dirt or
dust on the connector terminals and no foreign object between the
front panel and the main unit.
•
Attach the front panel carefully. Hold the panel by its sides to avoid
pushing any buttons by mistake.
Initial System Start-Up
Be sure to press the RESET switch when using the unit for the first
time, after changing the car battery, etc.
1
Turn off the unit power.
2
Press
(Release)
to remove the front panel.
3
Press
RESET
with a ballpoint pen or similar pointed
object.
Adjusting Volume
Turn the
Double Action encoder
(iDA-X303 only) or
Rotary encoder
(iDA-X301/iDA-X301RR only) until the
desired sound is obtained.
Getting Started
Double Action encoder
SOURCE
(Release)
Rotary encoder
SOURCE
(Release)
Controllable With Remote Control
Point the optional remote control transmitter at the remote
control sensor.
Connectable to Steering Remote Control Interface Box
You can operate this unit from the vehicle’s control unit when
an Alpine Steering Remote Control Interface Box (optional)
is connected. For details, contact your Alpine dealer.
Remote control sensor
