7
-EN
iDA-X200
iDA-X300
Accessory List
•
Digital Media receiver........................................................1
•
Power cable ........................................................................1
•
FULL SPEED
TM
Connection Cable
(iDA-X300 only) ..................................................................1
•
USB cable (iDA-X200 only)................................................1
•
iPod Dock interface cable (iDA-X200 only)......................1
•
Mounting sleeve.................................................................1
•
Carrying case .....................................................................1
•
Bracket key.........................................................................2
•
Screw (M5x8)......................................................................4
•
Owner’s Manual .......................................................... 1 set
Turning Power On and Off
Press
SOURCE
to turn on the unit.
•
The unit can be turned on by pressing any other button except
(Release),
Double Action encoder
(iDA-X200 only) and
VIEW
.
The unit is also automatically turned on if a USB memory is
connected.
Press and hold
SOURCE
for at least 2 seconds to turn
off the unit.
•
The first time power is turned on, the volume will start from level 12.
Detaching and Attaching the Front Panel
Detaching
1
Turn off the unit power.
2
Press
(Release) at the middle left side until the
front panel pops out.
3
Grasp the left side of the front panel and pull it out.
•
The front panel may become hot in normal usage (especially the
connector terminals on the back of the front panel.) This is not a
malfunction.
•
To protect the front panel, place it in the supplied carrying case.
Attaching
1
Insert the right side of the front panel into the main
unit. Align the groove on the front panel with the
projections on the main unit.
2
Push the left side of the front panel until it locks
firmly into the main unit.
•
Before attaching the front panel, make sure that there is no dirt or
dust on the connector terminals and no foreign object between the
front panel and the main unit.
•
Attach the front panel carefully. Hold the panel by its sides to avoid
pushing any buttons by mistake.
Initial System Start-Up
Be sure to press the RESET switch when using the unit for the first
time, after changing the car battery, etc.
1
Turn off the unit power.
2
Press
(Release) to remove the front panel.
3
Press
RESET
with a ballpoint pen or similar pointed
object.
Adjusting Volume
Turn the
Double Action encoder
(iDA-X200 only) or
Rotary encoder
(iDA-X300 only) until the desired
sound is obtained.
Getting Started
Double Action encoder
FUNC./SETUP
SOURCE
/ENTER
VIEW
Rotary encoder
FUNC./SETUP
SOURCE
/ENTER
VIEW
