15
-EN
01GB05CDA-9857R.fm
ALPINE CDA-9857R 68-04123Z54-A (EN)
Adjusting Bass/Treble/Balance (Between
Left and Right)/Fader (Between Front
and Rear)/Defeat
1
Press
MODE
repeatedly to choose the desired
mode.
Each press changes the mode as follows:
BASS
TREBLE
SUBWOOFER
*
BALANCE
FADER
DEFEAT
VOLUME
BASS
Bass level: –7 ~ +10
Treble level: –7 ~ +7
Subwoofer: 0 ~ +15
Balance: L15 ~ R15
Fader: R15 ~ F15
Defeat: ON/OFF
Volume: 0 ~ 35
•
If
MODE
is not pressed within 5 seconds after selecting the BASS,
TREBLE, BALANCE, FADER, DEFEAT or SUBWOOFER mode, the
unit automatically returns to normal mode.
* When the subwoofer mode is set to OFF, its level cannot be adjusted.
2
Turn the
Rotary encoder
until the desired sound is
obtained in each mode.
By setting Defeat ON, previously adjusted settings of BASS
and TREBLE will return to the factory defaults.
•
Depending on the connected devices, some functions and display
indications do not work.
Setting the Bass Control
You can change the Bass Frequency emphasis to create your own tonal
preference.
1
Press
MENU
to select the BASS ENGINE mode, then
press
MODE
.
BASS ENGINE
SETUP
RETURN (OFF)
BASS ENGINE
2
Press
or
to select the BASS (bass Centre
frequency) control mode.
BASS
TREBLE
3
-1 Press
SOURCE/POWER
to select the desired bass
centre frequency.
80Hz
100Hz
120Hz
60Hz
80Hz
Emphasizes the displayed bass frequency ranges.
3
-2 Press
BAND
to select the desired bass bandwidth.
Changes the boosted bass bandwidth to wide or narrow. A
wide setting will boost a wide range of frequencies above
and below the centre frequency. A narrower setting will
boost only frequencies near the centre frequency.
3
-3
*
1
Turn the
Rotary encoder
to select the desired
bass level (–7~+10).
You can emphasize or weaken the bass
level
.
4
Press
MENU
to select RETURN.
After 2 seconds, the unit returns to normal mode.
Pressing and holding
MENU
for at least 2 seconds will
return to normal mode.
•
If no operation is performed within 60 seconds, the bass control
setting will be turned off automatically.
•
The bass level settings will be individually memorized for each
source (FM, MW (LW), CD, etc.) until the setting is changed. The
bass frequency and bass bandwidth settings adjusted for one source
are effective for all other sources (FM, MW (LW), CD etc.).
•
Depending on the connected devices, some functions and display
indications do not work. However, Bass Level is still adjustable if an
audio processor with the Bass function is connected.
•
This function is inoperable when DEFEAT is set to ON.
•
If you press
or
in the bass control mode, the unit
changes to the treble control mode.
*
1
The adjustment can also be made by pressing the
MODE
. Refer to
“Adjusting Bass/Treble/Balance (Between Left and Right)/Fader
(Between Front and Rear)/Defeat” (page 15).
Sound Setting
BAND
Rotary encoder
MODE
SOURCE/POWER
MENU
Setting the Bass Centre Frequency
Setting the Bass Bandwidth
Setting the Bass Level
01GB00CDA-9857R.book Page 15 Thursday, December 1, 2005 4:38 PM
