31
-EN
1
Antenna Receptacle
Connect to the supplied ISO antenna convertor plug.
2
Audio Interrupt In Lead (Pink/Black)
Connect this lead to the Audio Interface output of a
cellular phone which provides ground shorting when
a call is received.
3
Remote Turn-On Lead (Blue/White)
Connect this lead to the remote turn-on lead of your
amplifier or signal processor.
4
Dimmer Lead (Orange)
This lead may be connected to the vehicle’s
instrument cluster illumination lead. This will enable
the vehicle’s dimmer control to dim the backlighting
of the CDA-7969R.
5
Switched Power Lead (Ignition) (Red)
Connect this lead to an open terminal on the vehicle’s
fuse box or another unused power source which
provides (+) 12V only when the ignition is turned on
or in the accessory position.
6
Power Antenna Lead (Blue)
Connect this lead to the +B terminal of your power
antenna, if applicable.
NOTE
This lead should be used only for controlling the
vehicle's power antenna. Do not use this lead to turn on
an amplifier or a signal processor, etc.
7
Fuse Holder (7.5A)
8
Battery Lead (Yellow)
Connect this lead to the positive (+) post of the
vehicle’s battery.
9
ISO Power Supply Connector
!
Ground Lead (Black)
Connect this lead to a good chassis ground on the
vehicle. Make sure the connection is made to bare
metal and is securely fastened using the sheet metal
screw provided.
"
Power Supply Connector
#
Ai-NET Connector
Connect this to the output or input connector of other
product (CD changer, Equalizer, etc.) equipped with
Ai-NET.
NOTE
You can input TV/video sound by connecting an
optional Ai-NET/RCA Interface cable (KCA-121B) to
this component.
$
The Digital Output Connector
Connect this to any other optical digital products of
ALPINE.
The digital signal will be output when the CD mode is
on.
%
Remote Control Interface Connector
To remote control interface box.
&
System Switch
When connecting an equalizer or divider using Ai-
NET feature, place this switch in the EQ/DIV
position. When no device is connected, leave the
switch in the NORM position.
NOTE
Be sure to turn the power off to the unit before changing
the switch position.
(
DC/DC Converter
NOTES
•
Do not install the converter at a location subjected to
water such as under the floor mat or air conditioner.
This may cause a malfunction.
•
Do not bundle the DC/DC converter cable with other
audio cables. Doing so may induce noise into your
system.
•
Keep the DC/DC converter away from the Antenna
cables and the rear side of the unit, otherwise noise
may be generated when receiving radio broadcast.
)
Ai-NET Cable (Included with CD Changer)
~
Front Output RCA Connectors
RED is right and WHITE is left.
+
Rear Output RCA Connectors
RED is right and WHITE is left.
,
Subwoofer RCA Connectors
RED is right and WHITE is left.
-
RCA Extension Cable (Sold Separately)
To prevent external noise from entering the audio system.
• Locate the unit and route the leads at least 10cm away from the car harness.
• Keep the battery power leads as far away from other leads as possible.
• Connect the ground lead securely to a bare metal spot (remove the coating if necessary) of the car chassis.
• If you add an optional noise suppressor, connect it as far away from the unit as possible. Your Alpine dealer carries
various Alpine noise suppressors, contact them for further information.
• Your Alpine dealer knows best about noise prevention measures so consult your dealer for further information.
Summary of Contents for CDA-7969R
Page 34: ...32 EN...
