ALPINE HCE-C305R_EN 68-23120Z52-A (A5)
20
-EN
4
Secure the camera cable. Attach the
waterproof pad
V
with the waterproof
pad adhesive sheet
W
, and secure any
slack cable around the waterproof pad
V
using the cord clamp
U
.
Reverse In
Camera cable
Ensure the cable does not get caught in the trunk,
rear door(s) or any hinges.
The cable should go on the outside of car hinges and
harness covers.
After completing wiring, open and close the trunk
and the rear doors several times to confirm the cable
is not getting caught or rubbing anywhere.
•
•
•
3. Installing the Buzzer
1
Attach the buzzer
O
with the supplied
double-faced adhesive tape
S
or screw
R
.
Before attaching the buzzer, wipe off any dust, oil,
etc., on the attaching surface with a suitable cleaning
cloth (sold separately).
Attach the buzzer in a location where driving is not
hindered.
Locations that are subject to high temperatures can
cause warping. Do not install in areas that receive
direct sunlight, such as the dashboard.
This is not a water resistant device. Do not get the
unit wet. Also, install so that the cable feed opening is
facing downwards to avoid water drops on the cable
falling into the alarm unit.
If the alarm hole is closed off, sound output may
become unstable. Do not place anything within 10
mm of the alarm hole.
Attaching with the double-face adhesive
tape
(1) Peel off the protective sheet on one
side, and apply it to the back of the
buzzer.
(2) Peel off the protective sheet on the
other side and apply to the desired
location in the car (under a seat, etc.).
If necessary, secure the cable with the
supplied cord clamp
T
.
Attaching with the screws
(1) Assemble the buzzer
O
and its
mounting bracket
P
.
(2) Install it in the desired location in
the car (under the seat, etc.) with the
supplied self-tapping screw
R
.
If necessary, secure the cable with the
supplied cord clamp
T
.
•
•
•
•
•
e
e
4. In
1
M
Bef
etc.
clo
Att
hin
•
•