INSTALLING DISPENSER CAUTION:
Make sure that no electrical wiring or pipe runs are located in the wall cavity
where the dispenser is to be installed.
TOOLS NEEDED
Phillips head screw driver
Drill
Drill bit
Stud finder
Pencil
1. Mount over a counter top no less than 16 inches (40cm) above counter. Do not install dispenser
over electrical outlets.
2. Hold the holster 16 against bare wall and mark location of screws on the wall.
3. Drill out 4 holes and insert wall anchors, install holster 16 and insert screws (do not over tighten
screws).
4. Return internal unit 14 into holster 16.
5. Return reservoir being sure pump tab 10 is inserted around flange 17.
6. Swing cover 1 back up and lock it into holster 16 until a clicking sound is heard. The dispenser is
now ready for use.
USING DISPENSER
AUTOMATIC
Place hands under dispenser to receive soap dose(s). Hands must be completely underneath both
sensors to activate dose.
www.alpineindustries.com
AUTOMATIC
SENSOR
BEAMS
Transmitting
light
Receiving
signal light
Effective sensing area
30,00 m
m
90,00 m
m
