20
Note that if you do not manually exit the priming mode as described above, the priming
mode will be automatically terminated after 4-5 minutes.
Be sure that the pump(s) have been primed by this time. Once the system has exited
Priming Mode, the top-side panel will momentarily display the set temperature but the
display will not show the temperature yet, as shown below. This is because the system
requires approximately 1 minute of water flow.
Pumps
To ensure proper functionality and component longevity, individual jet pumps
must not be cycled on and off more than one time every minute.
Press the “Jets” button
once to turn pump 1 on or off, and to shift between low
and high speeds if equipped.
If left running, the pump will turn off after a timeout period. The pump 1 low-speed will
time out after 30 minutes. The high-speed will time out after 15 minutes.
Circulation Pump Mode
If the system is equipped with a circulation pump, it will be configured to
work in one of three different ways:
1. The circulation pump operates continuously (24 hours) with the exception of
turning off for 30 minutes at a time when the water temperature reaches 3°F
(1.5°C) above the set temperature (most likely to happen in very hot climates).
2. The circulation pump stays on continuously, regardless of water temperature.
3. A programmable circulation pump will come on when the system is checking
temperature (polling), during filter cycles, during freeze conditions, or when
another pump is on.
The specific Circulation Mode that is used has been determined by the Manufacturer and
cannot be changed in the field.
