Document N° :
F2-1.0/R80/F/EU
Pioneer 200
Flight Manual
Section: 4
Normal Operations
REVISION :
0
Dated: 20-04-2002
Sect : 4 -Page: 9 of 98
4.3.4. STARTING ENGINE - HOT ENGINE.
Proceed as for cold engine above, but eliminate the priming operation 3.
Instead, open throttle to 1/4.
4.3.5. WARM-UP and FUNCTIONAL CHECK
Warm-up the engine with a fast idle of 1500 - 2500 RPM until the oil
temperature reaches 50 degrees C. During this phase, the cooling is
insufficient due to reduced airflow. It is therefore advisable not to shorten
the warm-up time by running the engine at higher RPM. The aircraft should
be pointed into wind to allow additional cooling air. As soon as the oil
reaches 50° C, it is possible to do the run-up.
4.3.6. BEFORE TAKEOFF
1 Brakes
CHECK
2
Cabin Doors
CLOSED & LATCHED
3
Flight Controls
FREE & CORRECT
4 Flight
Instruments
SET
5 Fuel
Shutoff
Valve
ON
6 Elevator
Trim NEUTRAL
7
Flaps
SET FOR TAKEOFF
8
Ignition Check
Throttle to 4000 RPM
Hold this engine speed for 10 seconds.
Switch OFF No. 1 Ignition and watch for RPM
drop.
Switch ON the No. 1 Ignition & switch OFF the
No. 2 Ignition watching for the RPM drop.
RPM drop should not exceed 200 RPM on
