10
EN
The rubber seal is a foam rubber pad that can be mounted between the access reader and the
mounting surface to ensure a better protection from water and moisture getting into the back of
the access reader. The rubber seal can also be used when mounting the access reader on an
uneven surface like a brick wall.
Measurements
Location
-
Determine the location where the AT-100 card reader should be installed. Please note that
there is a maximum cable length of 100m between the access reader and the card reader
interface or Door controller.
-
Keep a minimum distance of 20cm between AT-100 and AT-200P access readers.
-
The AT-100 should preferably not be installed directly on a metal surface. If this is
necessary, please use a spacer (see wiring: spacers) to achieve optimal reading distance.
