NUDV
– Installation and Operating Instructions
18
will be sufficient and the guard immediately responds by error tone, but he will extend
the period to hanging up..
Note 2.
The # sign is not used by entering of 32,33,34 parameters can be used for
immediate parameter entering.
3.2 Programming from PC – Program Nset
To guard’s setup by means of personal computer (PC) the special KAB cable
to serial port and Nset program should be available and the guard has to be
connected to telephone line.
Procedure:
-
Connect the NUDV to the line
-
Line the guard with PC by KAB cable (if PC serial port absent, the USB-
COM reduction is to be used). The guard will answer and LED light on the
front panel will light.
-
Run the Nset program – the guard will report the his conversion to PC
programming mode (viz. chapter 2.1 page 14). After Nset program being
run the guard is in this mode – this status is indicated by LED light on front
panel by 1 second flashing. By loss of connection it is necessary to
disconnect the cable from guard and connect it again – the guar will
answer and if Nset program runs he will report his conversion to
programming mode.
For details of setup refer to program help and on producer’s pages
www.alphatech.cz
.
Summary of Contents for NC - mod4
Page 2: ......
Page 34: ...NUDV Installation and Operating Instructions 34 ...
Page 38: ... JR 2004 9 version V8 1 I 09 ...