11
We reserve the right to modify technical specifications without prior notice.
83063900cUK – Translation of the operating manual
© ait-deutschland GmbH
•
Slowly and carefully tip the unit back into the
original position.
•
Repeat procedure on the other side of the unit.
Place unit at final installation location. Compensate
for minor unevenness using the four adjusting
screws. Then tighten the lock nuts.
INSTALLATION OF THE MODULE BOX
The entire cooling circuit of the heat station is contained
in the module box.
ATTENTION
Do not tilt the module box more than a maxi-
mum of 45° (in any direction).
Place module box in front of the unit.
1 Unit
2 Plug for electrical connection
3 Front edge of bottom of unit
4 Module box
Use straps to lift module box and initially place in
unit so that the rubber feet of the module box that
are facing the unit come to rest on the centring
plate behind the front edger of the bottom of the
unit.
Push module box into the unit until the front rubber
foot of the module box contacts the front edge of
the bottom of the unit and has to be lifted over it.
When pushing in the box, make sure that the plugs
for the electrical connection are not pinched and
damaged.
Raise module box, push it further into the unit and
lower the box as soon as the rubber feet contact
the corresponding stops of the centring plate.
Set the front left rubber foot of the module box
between
the guide elements.
The module box is positioned correctly in the unit
when the rubber feed are placed as shown in the
following sketch:
1 Stops on centring plate
2 Rear rubber feet of module box
3 Centring plate for module
box on bottom of unit
4 Front rubber feet of module box
5 Guide element
ATTENTION
Once the module box has been placed in the
unit, it may no longer be transported.
Summary of Contents for WZS 41-101H/SX
Page 44: ......
