Heatmaster 2
21
can switch the relay again after a certain period of time.
Action via button
Independent from the relays it is possible to trigger a set action with the push of a button. Choose the button
and then from the options “boost mode”, “stand-by”, “emergency shutdown” and “switch off all relays”.
Temperature-triggered relay switching
Choose ”temperature switch” and then the according sensors. With the setting “exceed” the relay is switched
when the temperature exceeds the set temperature. Only when both sensors undercut the set temperature
the relay will be switched back. Similarly it is also possible to switch the relay when a set temperature is
undercut. It switches back as soon as both sensors exceed the set temperature. This feature is very useful
for compressor-cooled systems as well as systems endangered by freezing.
Offline button / relay configuration
The offline relay / button control allows highly complex settings
to be made whilst the computer is switched off. The purpose of
this is, to allow the system to be booted via the Heatmaster 2
with a special booting procedure. This is especially useful when
using a compressor cooling system. The only requirement is an
active stand-by power supply as well as buttons and relays,
which will be available as accessories soon. Please note that
we have refrained from disabling settings which are
contradictory. Hence it is possible to make contradicting
switching procedures. The software is programmed that in the
worst case the procedures will not be executed or will be
executed with a delay in between. Please inform yourself very
thoroughly about the options and possibilities before configuring
a switching procedure.
Starting schedule
Here a schedule can be set for each button. If the button is
pushed while the system is in stand-by, the allocated starting
schedule will be initiated. After the schedule has been started it
is possible to initiate further actions by pushing further buttons
or the original button again.
Button / relay settings
Every button can have one or multiple relays assigned. The relays can be switched immediately after the
button is pushed or with a delay. After the button is pushed again, the set timed action is executed again. Of
other direct (without timed actions) relay activations are triggered e.g. by the push of another button, they do
not influence the timed actions.
Heatmaster 2 can boot PC:
Use this feature to e.g. boot the system automatically with a delay after the compressor cooling has started.
