3
The
flat side
of the sensors must point to the
back
of the of the vehicle with the
curved side to the front. The cables must point
up
.
The sensors must be installed at a 90-degree angle, perpendicular to the ground.
The installation angle (
±
θ
) depends on the height of the bumper from the ground.
Installation Height (±10 cm)
Installation Angle (
θ
)
40 cm
0° to 5°
45 cm
-5° to 5°
50 cm
-5° to 0°
55 cm
-5° to 0°
60 cm
-10°
65 cm
-10°
If the inside of the bumper is uneven, the gap between the sensor and the
uneven bumper should not be more than 1 mm.
The sensors will receive power from the reverse light of the vehicle. Connect the
power
(12V) and
ground
cables to the power (12V) and
ground cables of the reverse light.
When installation is complete, the bumper can be re-installed onto the vehicle. No electronic/electric
products or equipment that contain metal
should be between the sensors and the area of detection.
I
NITIALIZATION
To initialize the ARS-SM01, after the installation, clear the area behind the vehicle (1 meter) of any obstructions and press the
BGC
toggle
switch
. BGC stands for Background Check. The initialization process is as follows:
x
With the vehicle turned on, power the reverse lights by shifting the gear stick/selector (manual/automatic) into the reverse position.
x
Toggle the BGC switch to the on (I) position.
x
Wait until the buzzer makes a sound for longer than 1 second.
x
Toggle the BGC switch to the off (O) position.
x
Wait until the buzzer sound stops (about 3 seconds).
After the buzzer sound stopped, the initialization process is complete and the ARS-SM01 is ready for use.
Cable
Side View
+
θ
-
θ
0 ~ 1 mm
Summary of Contents for ARS-SM01
Page 1: ......
