012-526-B2 Rev C
Page 9 of 20
To remove a converter module, loosen the thumbscrew (1/4-turn) latch on the bottom of the faceplate. Grasp
handle and pull out, sliding the module away from the rear connector and out of the shelf.
4.5
CXCI
Refer to Maintenance chapter for CXCI Replacement Procedure.
4.5.1
CXCI Blank Plate Removal
Remove converter in the left-most position in order to access the side of the CXCI where the mounting screws are
located.
Figure 3–Showing CXCI blank plate removal
4.5.2
CXCI Module Installation
Remove CXCI blank plate as described previously.
Remove baffle (via front-mounting screw) if you have not already done so.
Figure 4–Baffle and pem removal
CXCI blank plate
Baffle
Side-mounting screw (2PL) –
remove to release CXCI blank plate
Front -mounting screw –
remove to release baffle
Remove pem before
installation of CXCI
Remove front-mounting
screw to release baffle
Baffle and
pem removed
