BELT REMOVAL AND REPLACEMENT
The Ecocutter incorporates two drive belts (an inner and outer) to power the fan assembly.
If the unit is not removing the dust, you will need to inspect the belts, fan assembly, and
dust bag to find the cause of the problem.
Note: The Ecocutter makes use of a flat belt and pulley system that is self-centering due to
the barrel shape of the pulleys. If the belt is worn or dirty it can rotate off the pulleys,
(this will be indicated by a loss of suction).
7.
Check to see if the two parts move freely by pushing the top plate of the carbon
brush into the recess on the bottom of the carbon brush cap and rotate.
Carbon Brush and Cap
Figure-29
Top Plate
22
8.
If the two parts stick together, replace the carbon brush cap and repeat step 7.
9.
If the top plate of the carbon brush sticks in the new cap, you need to replace the
carbon brush and repeat step 7.
10. Keep trying until carbon brush top plate can move freely inside of the recess on the
bottom of carbon brush cap.
11. When the correct match is found, install in the tool.