®
3
017-877-B0-001 Rev. B (08/2020)
Reset Timing [J12]
Verify the jumper is in position 2 and 3 when using the DM3 Comm Module in
an XM2-300HP Power Supply.
1
2
3
XM3
XM2-300
J12
J12
J12
1
2
3
For general product information or customer service call: +49 9122 79889 0
Notice of FCC Compliance
Compliance and Support
Fig. 5, Location and setting of J12 on DM3
Verification of Jumper Settings on DM3
To confirm the correct DM3 Comm Module configuration for the XM2-300HP Power Supply, locate the Reset Timing Jumper
[J12]; verify pin shorting connector is set as indicated below.
Per FCC 47 CFR 15.21:
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the
equipment.
Per FCC 47 CFR 15.105:
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction
manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the interference at their own expense.
Product and Technical Support
